/* SPDX-License-Identifier: GPL-2.0+ */
/*
 ******************************************************************************
 * @file    flat_roll_inward_x_y_0110_ST.h
 * @author  Sensors Software Solution Team
 * @brief   This file contains the configuration for flat_roll_inward_x_y_0110_ST.
 *
 ******************************************************************************
 * @attention
 *
 * <h2><center>&copy; Copyright (c) 2021 STMicroelectronics.
 * All rights reserved.</center></h2>
 *
 * This software component is licensed by ST under BSD 3-Clause license,
 * the "License"; You may not use this file except in compliance with the
 * License. You may obtain a copy of the License at:
 *                        opensource.org/licenses/BSD-3-Clause
 *
 */

/* Define to prevent recursive inclusion -------------------------------------*/
#ifndef FLAT_ROLL_INWARD_X_Y_H
#define FLAT_ROLL_INWARD_X_Y_H

#ifdef __cplusplus
extern "C" {
#endif

/* Includes ------------------------------------------------------------------*/
#ifndef MEMS_UCF_SHARED_TYPES
#define MEMS_UCF_SHARED_TYPES

/** Common data block definition **/
struct ucf_line_t {
	uint8_t address;
	uint8_t data;
};

#endif /* MEMS_UCF_SHARED_TYPES */

#ifdef __cplusplus
}
#endif

#endif /* FLAT_ROLL_INWARD_X_Y_H */