/*
 * Copyright (c) 2017 Rockchip Electronics Co., Ltd
 *
 * SPDX-License-Identifier:     GPL-2.0+
 */
#include <asm/io.h>
#include <asm/arch/hardware.h>
#include <asm/arch/bootrom.h>
#include <asm/arch/grf_rk3128.h>

#define GRF_GPIO1C_IOMUX		0x200080c0
#define SDMMC_INTMASK			0x10214024
#define READLATENCY_VAL			0x3f
#define BUS_MSCH_QOS_BASE		0x10128014
#define	CPU_AXI_QOS_PRIORITY_BASE	0x1012f188
#define CPU_AXI_QOS_PRIORITY_LEVEL(h, l) \
	((((h) & 3) << 8) | (((h) & 3) << 2) | ((l) & 3))
#define	CPU_AXI_CIF_QOS_PRIORITY_BASE	0x1012f208

int arch_cpu_init(void)
{
	/* We do some SoC one time setting here. */

	/* Read latency configure */
	writel(READLATENCY_VAL, BUS_MSCH_QOS_BASE);

	/* Set lcdc cpu axi qos priority level */
	writel(CPU_AXI_QOS_PRIORITY_LEVEL(3, 3), CPU_AXI_QOS_PRIORITY_BASE);

	/* Set GPIO1_C1 iomux to gpio, default sdcard_detn */
	writel(0x00040000, GRF_GPIO1C_IOMUX);

#ifdef CONFIG_ROCKCHIP_RK3126
	/*
	 * Disable interrupt, otherwise it always generates wakeup signal. This
	 * is an IC hardware issue.
	 */
	writel(0, SDMMC_INTMASK);

	/* raise cif ddr qos priority */
	writel(CPU_AXI_QOS_PRIORITY_LEVEL(3, 3), CPU_AXI_CIF_QOS_PRIORITY_BASE);
#endif

	return 0;
}

void board_debug_uart_init(void)
{
	struct rk3128_grf * const grf __maybe_unused =
		(struct rk3128_grf * const)0x20008000;

	enum {
		/* UART2 */
		GPIO1C2_SHIFT		= 4,
		GPIO1C2_MASK		= GENMASK(5, 4),
		GPIO1C2_GPIO		= 0,
		GPIO1C2_MMC0_D0		= 1,
		GPIO1C2_UART2_TX	= 2,

		GPIO1C3_SHIFT		= 6,
		GPIO1C3_MASK		= GENMASK(7, 6),
		GPIO1C3_GPIO		= 0,
		GPIO1C2_MMC0_D1		= 1,
		GPIO1C2_UART2_RX	= 2,
	};

	rk_clrsetreg(&grf->gpio1c_iomux,
		     GPIO1C2_MASK, GPIO1C2_UART2_TX << GPIO1C2_SHIFT);
	rk_clrsetreg(&grf->gpio1c_iomux,
		     GPIO1C3_MASK, GPIO1C2_UART2_RX << GPIO1C3_SHIFT);
}