From 87c7c0d90966d729ca3d39cbfca77a39a43960eb Mon Sep 17 00:00:00 2001
From: liyujie <2352380935@qq.com>
Date: Fri, 29 Aug 2025 09:04:04 +0000
Subject: [PATCH] 解决板卡插入usb摄像头上电，打不开摄像头的问题
---
longan/device/config/chips/a133/configs/c3/kickpi-k5c.dts | 136 +++++++++++++++++++++-----------------------
1 files changed, 65 insertions(+), 71 deletions(-)
diff --git a/longan/device/config/chips/a133/configs/c3/kickpi-k5c.dts b/longan/device/config/chips/a133/configs/c3/kickpi-k5c.dts
index c53fb05..c8c2b60 100755
--- a/longan/device/config/chips/a133/configs/c3/kickpi-k5c.dts
+++ b/longan/device/config/chips/a133/configs/c3/kickpi-k5c.dts
@@ -17,15 +17,15 @@
standby_param = &standby_param;
};
- reg_usb1_vbus: usb1-vbus {
+ reg_usb1_vbus: usb1-vbus {
compatible = "regulator-fixed";
- gpio = <&r_pio PL 8 1 2 0 1>;
+ //gpio = <&r_pio PL 8 1 2 0 1>;
regulator-name = "usb1-vbus";
regulator-min-microvolt = <5000000>;
regulator-max-microvolt = <5000000>;
regulator-enable-ramp-delay = <1000>;
enable-active-high;
- };
+ };
soc: soc@03000000 {
@@ -288,25 +288,6 @@
pinctrl-0 = <&twi0_pins_a>;
pinctrl-1 = <&twi0_pins_b>;
status = "okay";
- ctp {
- compatible = "gt9xx_ts";
- ctp_used = <1>;
- device_type = "ctp";
- status = "okay";
- ctp_twi_id = <0x0>;
- ctp_name = "gt9xx";
- reg = <0x5D>;
- ctp_screen_max_x = <1024>;
- ctp_screen_max_y = <600>;
- ctp_revert_x_flag = <0x1>;
- ctp_revert_y_flag = <0x1>;
- ctp_exchange_x_y_flag = <0x0>;
- ctp_int_port = <&pio PE 3 6 0xffffffff 0xffffffff 0>;
- ctp_wakeup = <&pio PE 4 1 0xffffffff 0xffffffff 1>;
- ctp_power_ldo = <3300>;
- ctp_power_ldo_vol = <3300>;
- ctp_power = <3300>;
- };
};
spi0: spi@05010000 {
@@ -428,10 +409,10 @@
compatible = "x-powers,axp803-usb-power-supply";
status = "okay";
- pmu_usbpc_vol = <5000>;
- pmu_usbpc_cur = <5000>;
- pmu_usbad_vol = <5000>;
- pmu_usbad_cur = <5000>;
+ pmu_usbpc_vol = <4600>;
+ pmu_usbpc_cur = <2500>;
+ pmu_usbad_vol = <4600>;
+ pmu_usbad_cur = <2500>;
wakeup_usb_in;
wakeup_usb_out;
@@ -442,21 +423,21 @@
status = "okay";
pmu_chg_ic_temp = <0>;
- pmu_battery_rdc= <93>;
- pmu_battery_cap = <5067>;
+ pmu_battery_rdc= <50>;
+ pmu_battery_cap = <8000>;
pmu_runtime_chgcur = <1000>;
pmu_suspend_chgcur = <2000>;
pmu_shutdown_chgcur = <2000>;
- pmu_init_chgvol = <4200>;
+ pmu_init_chgvol = <4280>;
pmu_battery_warning_level1 = <15>;
pmu_battery_warning_level2 = <0>;
- pmu_chgled_func = <0>;
+ pmu_chgled_func = <1>;
pmu_chgled_type = <0>;
ocv_coulumb_100 = <1>;
pmu_bat_para1 = <0>;
- pmu_bat_para2 = <0>;
- pmu_bat_para3 = <0>;
- pmu_bat_para4 = <0>;
+ pmu_bat_para2 = <3>;
+ pmu_bat_para3 = <4>;
+ pmu_bat_para4 = <5>;
pmu_bat_para5 = <6>;
pmu_bat_para6 = <8>;
pmu_bat_para7 = <9>;
@@ -474,16 +455,16 @@
pmu_bat_para19 = <65>;
pmu_bat_para20 = <70>;
pmu_bat_para21 = <75>;
- pmu_bat_para22 = <80>;
- pmu_bat_para23 = <83>;
- pmu_bat_para24 = <84>;
- pmu_bat_para25 = <86>;
- pmu_bat_para26 = <90>;
- pmu_bat_para27 = <94>;
- pmu_bat_para28 = <97>;
- pmu_bat_para29 = <99>;
- pmu_bat_para30 = <100>;
- pmu_bat_para31 = <100>;
+ pmu_bat_para22 = <76>;
+ pmu_bat_para23 = <77>;
+ pmu_bat_para24 = <78>;
+ pmu_bat_para25 = <79>;
+ pmu_bat_para26 = <80>;
+ pmu_bat_para27 = <83>;
+ pmu_bat_para28 = <85>;
+ pmu_bat_para29 = <88>;
+ pmu_bat_para30 = <90>;
+ pmu_bat_para31 = <95>;
pmu_bat_para32 = <100>;
pmu_bat_temp_enable = <0>;
@@ -509,7 +490,7 @@
pmu_bat_temp_para16 = <66>;
wakeup_bat_out;
- /* wakeup_bat_in; */
+ wakeup_bat_in;
/* wakeup_bat_charging; */
/* wakeup_bat_charge_over; */
/* wakeup_low_warning1; */
@@ -523,7 +504,7 @@
powerkey0: powerkey@0 {
status = "okay";
compatible = "x-powers,axp2101-pek";
- pmu_powkey_off_time = <6000>;
+ pmu_powkey_off_time = <8000>;
pmu_powkey_off_func = <0>;
pmu_powkey_off_en = <1>;
pmu_powkey_long_time = <1500>;
@@ -943,13 +924,13 @@
status = "okay";
};
- ehci1:ehci1-controller@0x05200000 {
+ ehci1:ehci1-controller@0x05200000 {
drvvbus-supply = <®_usb1_vbus>;
};
ohci1:ohci1-controller@0x05200400 {
drvvbus-supply = <®_usb1_vbus>;
- };
+ };
sdc1: sdmmc@04021000 {
bus-width = <4>;
@@ -960,7 +941,7 @@
/*sd-uhs-sdr25*/
sd-uhs-sdr50;
sd-uhs-ddr50;
- sd-uhs-sdr104;
+ //sd-uhs-sdr104;
// kickpi
//sunxi-power-save-mode;
/*sunxi-dis-signal-vol-sw;*/
@@ -991,9 +972,9 @@
lineout_vol = <0x1a>;
headphonegain = <0x00>;
/* Pa enabled about */
- pa_level = <0x00>;
+ pa_level = <0x01>;
pa_msleep_time = <0x78>;
- //gpio-spk = <&pio PB 7 1 1 1 1>;
+ gpio-spk = <&pio PB 7 1 1 1 1>;
/* regulator about */
avcc-supply = <®_aldo1>;
cpvin-supply = <®_eldo1>;
@@ -1334,6 +1315,10 @@
uart4: uart@05001000 {
status = "okay";
};
+
+ uart7: uart@07080000 {
+ status = "okay";
+ };
};
gpu: gpu@0x01800000 {
gpu_idle = <1>;/*ic version ctrl*/
@@ -1355,17 +1340,23 @@
pinctrl-names = "default";
status = "okay";
- sysled {
- label = "sysled";
- gpios = <&r_pio PL 10 1 0 1 1>;
+ usb_vbus {
+ abel = "usb_vbus";
+ gpios = <&r_pio PL 8 1 2 0 1>;
+ linux,default_trigger = "default-on";
+ };
+
+ work-led {
+ label = "work-led";
+ gpios = <&r_pio PL 10 1 0 1 0>;
linux,default_trigger = "heartbeat";
};
- spk_en {
- label = "spk_en";
- gpios = <&pio PB 7 1 0 1 0>;
- linux,default_trigger = "default-on";
- };
+ // spk_en {
+ // label = "spk_en";
+ // gpios = <&pio PB 7 1 0 1 0>;
+ // linux,default_trigger = "default-on";
+ // };
fan_en {
label = "fan_en";
@@ -1409,17 +1400,17 @@
linux,default_trigger = "default-on";
};
- PL2 {
- label = "PL2";
- gpios = <&r_pio PL 2 1 0 1 0>;
- linux,default_trigger = "default-on";
- };
+ // PL2 {
+ // label = "PL2";
+ // gpios = <&r_pio PL 2 1 0 1 0>;
+ // linux,default_trigger = "default-on";
+ // };
- PL3 {
- label = "PL3";
- gpios = <&r_pio PL 3 1 0 1 0>;
- linux,default_trigger = "default-on";
- };
+ // PL3 {
+ // label = "PL3";
+ // gpios = <&r_pio PL 3 1 0 1 0>;
+ // linux,default_trigger = "default-on";
+ // };
PL4 {
label = "PL4";
@@ -1463,8 +1454,11 @@
rx-delay = <7>;
};
-
+//#include "lcd-lvds-7-1024-600.dtsi"
//#include "lcd-lvds-21-1920-1080.dtsi"
-#include "lcd-lvds-7-1024-600.dtsi"
-//#include "lcd-mipi-10-800-1280.dtsi"
+//#include "lcd-mipi-10-800-1280-v1.dtsi"
+#include "lcd-mipi-10-800-1280-v2.dtsi"
//#include "lcd-mipi-8-800-1280.dtsi"
+//#include "lcd-mipi-5-720-1280.dtsi"
+
+#include "a133-kickpi-axp707-bat-5000mA.dtsi"
--
Gitblit v1.6.2