From 9d77db3c730780c8ef5ccd4b66403ff5675cfe4e Mon Sep 17 00:00:00 2001
From: hc <hc@nodka.com>
Date: Mon, 13 May 2024 10:30:14 +0000
Subject: [PATCH] modify sin led gpio
---
kernel/Documentation/devicetree/bindings/net/mscc-phy-vsc8531.txt | 24 ++++++++++++------------
1 files changed, 12 insertions(+), 12 deletions(-)
diff --git a/kernel/Documentation/devicetree/bindings/net/mscc-phy-vsc8531.txt b/kernel/Documentation/devicetree/bindings/net/mscc-phy-vsc8531.txt
index 0eedabe..87a27d7 100644
--- a/kernel/Documentation/devicetree/bindings/net/mscc-phy-vsc8531.txt
+++ b/kernel/Documentation/devicetree/bindings/net/mscc-phy-vsc8531.txt
@@ -1,10 +1,5 @@
* Microsemi - vsc8531 Giga bit ethernet phy
-Required properties:
-- compatible : Should contain phy id as "ethernet-phy-idAAAA.BBBB"
- The PHY device uses the binding described in
- Documentation/devicetree/bindings/net/phy.txt
-
Optional properties:
- vsc8531,vddmac : The vddmac in mV. Allowed values is listed
in the first row of Table 1 (below).
@@ -27,14 +22,18 @@
'vddmac'.
Default value is 0%.
Ref: Table:1 - Edge rate change (below).
-- vsc8531,led-0-mode : LED mode. Specify how the LED[0] should behave.
- Allowed values are define in
+- vsc8531,led-[N]-mode : LED mode. Specify how the LED[N] should behave.
+ N depends on the number of LEDs supported by a
+ PHY.
+ Allowed values are defined in
"include/dt-bindings/net/mscc-phy-vsc8531.h".
- Default value is VSC8531_LINK_1000_ACTIVITY (1).
-- vsc8531,led-1-mode : LED mode. Specify how the LED[1] should behave.
- Allowed values are define in
- "include/dt-bindings/net/mscc-phy-vsc8531.h".
- Default value is VSC8531_LINK_100_ACTIVITY (2).
+ Default values are VSC8531_LINK_1000_ACTIVITY (1),
+ VSC8531_LINK_100_ACTIVITY (2),
+ VSC8531_LINK_ACTIVITY (0) and
+ VSC8531_DUPLEX_COLLISION (8).
+- load-save-gpios : GPIO used for the load/save operation of the PTP
+ hardware clock (PHC).
+
Table: 1 - Edge rate change
----------------------------------------------------------------|
@@ -70,4 +69,5 @@
vsc8531,edge-slowdown = <7>;
vsc8531,led-0-mode = <LINK_1000_ACTIVITY>;
vsc8531,led-1-mode = <LINK_100_ACTIVITY>;
+ load-save-gpios = <&gpio 10 GPIO_ACTIVE_HIGH>;
};
--
Gitblit v1.6.2