From 9d77db3c730780c8ef5ccd4b66403ff5675cfe4e Mon Sep 17 00:00:00 2001
From: hc <hc@nodka.com>
Date: Mon, 13 May 2024 10:30:14 +0000
Subject: [PATCH] modify sin led gpio
---
kernel/Documentation/devicetree/bindings/mmc/sdhci-atmel.txt | 18 +++++++++++++++---
1 files changed, 15 insertions(+), 3 deletions(-)
diff --git a/kernel/Documentation/devicetree/bindings/mmc/sdhci-atmel.txt b/kernel/Documentation/devicetree/bindings/mmc/sdhci-atmel.txt
index 1b662d7..69edfd4 100644
--- a/kernel/Documentation/devicetree/bindings/mmc/sdhci-atmel.txt
+++ b/kernel/Documentation/devicetree/bindings/mmc/sdhci-atmel.txt
@@ -5,17 +5,29 @@
sdhci-of-at91 driver.
Required properties:
-- compatible: Must be "atmel,sama5d2-sdhci".
+- compatible: Must be "atmel,sama5d2-sdhci" or "microchip,sam9x60-sdhci".
- clocks: Phandlers to the clocks.
-- clock-names: Must be "hclock", "multclk", "baseclk";
+- clock-names: Must be "hclock", "multclk", "baseclk" for
+ "atmel,sama5d2-sdhci".
+ Must be "hclock", "multclk" for "microchip,sam9x60-sdhci".
+Optional properties:
+- assigned-clocks: The same with "multclk".
+- assigned-clock-rates The rate of "multclk" in order to not rely on the
+ gck configuration set by previous components.
+- microchip,sdcal-inverted: when present, polarity on the SDCAL SoC pin is
+ inverted. The default polarity for this signal is described in the datasheet.
+ For instance on SAMA5D2, the pin is usually tied to the GND with a resistor
+ and a capacitor (see "SDMMC I/O Calibration" chapter).
Example:
-sdmmc0: sdio-host@a0000000 {
+mmc0: sdio-host@a0000000 {
compatible = "atmel,sama5d2-sdhci";
reg = <0xa0000000 0x300>;
interrupts = <31 IRQ_TYPE_LEVEL_HIGH 0>;
clocks = <&sdmmc0_hclk>, <&sdmmc0_gclk>, <&main>;
clock-names = "hclock", "multclk", "baseclk";
+ assigned-clocks = <&sdmmc0_gclk>;
+ assigned-clock-rates = <480000000>;
};
--
Gitblit v1.6.2