From 9999e48639b3cecb08ffb37358bcba3b48161b29 Mon Sep 17 00:00:00 2001
From: hc <hc@nodka.com>
Date: Fri, 10 May 2024 08:50:17 +0000
Subject: [PATCH] add ax88772_rst

---
 kernel/arch/arm/boot/dts/sun7i-a20-olimex-som204-evb.dts |   60 ++++++++++++++++++++++++++----------------------------------
 1 files changed, 26 insertions(+), 34 deletions(-)

diff --git a/kernel/arch/arm/boot/dts/sun7i-a20-olimex-som204-evb.dts b/kernel/arch/arm/boot/dts/sun7i-a20-olimex-som204-evb.dts
index 3d7b5c8..230d62a 100644
--- a/kernel/arch/arm/boot/dts/sun7i-a20-olimex-som204-evb.dts
+++ b/kernel/arch/arm/boot/dts/sun7i-a20-olimex-som204-evb.dts
@@ -78,7 +78,7 @@
 
 &can0 {
 	pinctrl-names = "default";
-	pinctrl-0 = <&can0_pins_a>;
+	pinctrl-0 = <&can_ph_pins>;
 	status = "okay";
 };
 
@@ -104,19 +104,11 @@
 
 &gmac {
 	pinctrl-names = "default";
-	pinctrl-0 = <&gmac_pins_rgmii_a>;
-	phy = <&phy3>;
+	pinctrl-0 = <&gmac_rgmii_pins>;
+	phy-handle = <&phy3>;
 	phy-mode = "rgmii";
 	phy-supply = <&reg_vcc3v3>;
-
-	snps,reset-gpio = <&pio 0 17 GPIO_ACTIVE_HIGH>;
-	snps,reset-active-low;
-	snps,reset-delays-us = <0 10000 1000000>;
 	status = "okay";
-
-	phy3: ethernet-phy@3 {
-		reg = <3>;
-	};
 };
 
 &hdmi {
@@ -130,8 +122,6 @@
 };
 
 &i2c0 {
-	pinctrl-names = "default";
-	pinctrl-0 = <&i2c0_pins_a>;
 	status = "okay";
 
 	axp209: pmic@34 {
@@ -143,8 +133,6 @@
 
 /* Exposed to UEXT1 */
 &i2c1 {
-	pinctrl-names = "default";
-	pinctrl-0 = <&i2c1_pins_a>;
 	status = "okay";
 
 	eeprom: eeprom@50 {
@@ -156,20 +144,26 @@
 
 /* Exposed to UEXT2 */
 &i2c2 {
-	pinctrl-names = "default";
-	pinctrl-0 = <&i2c2_pins_a>;
 	status = "okay";
 };
 
 &ir0 {
 	pinctrl-names = "default";
-	pinctrl-0 = <&ir0_rx_pins_a>;
+	pinctrl-0 = <&ir0_rx_pin>;
 	status = "okay";
 };
 
+&gmac_mdio {
+	phy3: ethernet-phy@3 {
+		reg = <3>;
+		reset-gpios = <&pio 0 17 GPIO_ACTIVE_LOW>; /* PA17 */
+		reset-assert-us = <10000>;
+		/* wait 1s after reset, otherwise fail to read phy id */
+		reset-deassert-us = <1000000>;
+	};
+};
+
 &mmc0 {
-	pinctrl-names = "default";
-	pinctrl-0 = <&mmc0_pins_a>;
 	vmmc-supply = <&reg_vcc3v3>;
 	bus-width = <4>;
 	cd-gpios = <&pio 7 1 GPIO_ACTIVE_LOW>;
@@ -177,8 +171,6 @@
 };
 
 &mmc3 {
-	pinctrl-names = "default";
-	pinctrl-0 = <&mmc3_pins_a>;
 	vmmc-supply = <&reg_vcc3v3>;
 	mmc-pwrseq = <&rtl_pwrseq>;
 	bus-width = <4>;
@@ -203,8 +195,8 @@
 };
 
 &pio {
-	bt_uart_pins: bt_uart_pins@0 {
-		pins = "PG6", "PG7", "PG8";
+	uart3_rts_pin: uart3-rts-pin {
+		pins = "PG8";
 		function = "uart3";
 	};
 };
@@ -274,43 +266,43 @@
 /* Exposed to UEXT1 */
 &spi1 {
 	pinctrl-names = "default";
-	pinctrl-0 = <&spi1_pins_a>,
-		    <&spi1_cs0_pins_a>;
+	pinctrl-0 = <&spi1_pi_pins>,
+		    <&spi1_cs0_pi_pin>;
 	status = "okay";
 };
 
 /* Exposed to UEXT2 */
 &spi2 {
 	pinctrl-names = "default";
-	pinctrl-0 = <&spi2_pins_a>,
-		    <&spi2_cs0_pins_a>;
+	pinctrl-0 = <&spi2_pc_pins>,
+		    <&spi2_cs0_pc_pin>;
 	status = "okay";
 };
 
 &uart0 {
 	pinctrl-names = "default";
-	pinctrl-0 = <&uart0_pins_a>;
+	pinctrl-0 = <&uart0_pb_pins>;
 	status = "okay";
 };
 
 /* Used for RTL8723BS bluetooth */
 &uart3 {
 	pinctrl-names = "default";
-	pinctrl-0 = <&bt_uart_pins>;
+	pinctrl-0 = <&uart3_pg_pins>, <&uart3_rts_pin>;
 	status = "okay";
 };
 
 /* Exposed to UEXT1 */
 &uart4 {
 	pinctrl-names = "default";
-	pinctrl-0 = <&uart4_pins_a>;
+	pinctrl-0 = <&uart4_pg_pins>;
 	status = "okay";
 };
 
 /* Exposed to UEXT2 */
 &uart7 {
 	pinctrl-names = "default";
-	pinctrl-0 = <&uart7_pins_a>;
+	pinctrl-0 = <&uart7_pi_pins>;
 	status = "okay";
 };
 
@@ -324,8 +316,8 @@
 };
 
 &usbphy {
-	usb0_id_det-gpio = <&pio 7 4 GPIO_ACTIVE_HIGH>; /* PH4 */
-	usb0_vbus_det-gpio = <&pio 7 5 GPIO_ACTIVE_HIGH>; /* PH5 */
+	usb0_id_det-gpios = <&pio 7 4 GPIO_ACTIVE_HIGH>; /* PH4 */
+	usb0_vbus_det-gpios = <&pio 7 5 GPIO_ACTIVE_HIGH>; /* PH5 */
 	usb0_vbus_power-supply = <&usb_power_supply>;
 	usb0_vbus-supply = <&reg_usb0_vbus>;
 	usb1_vbus-supply = <&reg_usb1_vbus>;

--
Gitblit v1.6.2