From 8ac6c7a54ed1b98d142dce24b11c6de6a1e239a5 Mon Sep 17 00:00:00 2001 From: hc <hc@nodka.com> Date: Tue, 22 Oct 2024 10:36:11 +0000 Subject: [PATCH] 修改4g拨号为QMI,需要在系统里后台执行quectel-CM --- kernel/drivers/staging/octeon-usb/octeon-hcd.h | 10 +++++----- 1 files changed, 5 insertions(+), 5 deletions(-) diff --git a/kernel/drivers/staging/octeon-usb/octeon-hcd.h b/kernel/drivers/staging/octeon-usb/octeon-hcd.h index 769c36c..9ed619c 100644 --- a/kernel/drivers/staging/octeon-usb/octeon-hcd.h +++ b/kernel/drivers/staging/octeon-usb/octeon-hcd.h @@ -1711,7 +1711,7 @@ * Indicates an internal error was detected during * the BIST sequence. * @tdata_out: PHY Test Data Out. - * Presents either internaly generated signals or + * Presents either internally generated signals or * test register contents, based upon the value of * test_data_out_sel. * @siddq: Drives the USBP (USB-PHY) SIDDQ input. @@ -1737,7 +1737,7 @@ * to D+. When an A/B device is acting as a host * (downstream-facing port), dp_pulldown and * dm_pulldown are enabled. This must not toggle - * during normal opeartion. + * during normal operation. * @dm_pulld: PHY DM_PULLDOWN input to the USB-PHY. * This signal enables the pull-down resistance on * the D- line. '1' pull down-resistance is connected @@ -1745,7 +1745,7 @@ * to D-. When an A/B device is acting as a host * (downstream-facing port), dp_pulldown and * dm_pulldown are enabled. This must not toggle - * during normal opeartion. + * during normal operation. * @hst_mode: When '0' the USB is acting as HOST, when '1' * USB is acting as device. This field needs to be * set while the USB is in reset. @@ -1784,7 +1784,7 @@ * Used to activate BIST in the PHY. * @tdata_sel: Test Data Out Select. * '1' test_data_out[3:0] (PHY) register contents - * are output. '0' internaly generated signals are + * are output. '0' internally generated signals are * output. * @taddr_in: Mode Address for Test Interface. * Specifies the register address for writing to or @@ -1797,7 +1797,7 @@ * This is a test signal. When the USB Core is * powered up (not in Susned Mode), an automatic * tester can use this to disable phy_clock and - * free_clk, then re-eanable them with an aligned + * free_clk, then re-enable them with an aligned * phase. * '1': The phy_clk and free_clk outputs are * disabled. "0": The phy_clock and free_clk outputs -- Gitblit v1.6.2