From 8ac6c7a54ed1b98d142dce24b11c6de6a1e239a5 Mon Sep 17 00:00:00 2001 From: hc <hc@nodka.com> Date: Tue, 22 Oct 2024 10:36:11 +0000 Subject: [PATCH] 修改4g拨号为QMI,需要在系统里后台执行quectel-CM --- kernel/Documentation/devicetree/bindings/pinctrl/meson,pinctrl.txt | 29 +++++++++++++++++++++-------- 1 files changed, 21 insertions(+), 8 deletions(-) diff --git a/kernel/Documentation/devicetree/bindings/pinctrl/meson,pinctrl.txt b/kernel/Documentation/devicetree/bindings/pinctrl/meson,pinctrl.txt index 54ecb8a..0aff1f2 100644 --- a/kernel/Documentation/devicetree/bindings/pinctrl/meson,pinctrl.txt +++ b/kernel/Documentation/devicetree/bindings/pinctrl/meson,pinctrl.txt @@ -13,6 +13,9 @@ "amlogic,meson-gxl-aobus-pinctrl" "amlogic,meson-axg-periphs-pinctrl" "amlogic,meson-axg-aobus-pinctrl" + "amlogic,meson-g12a-periphs-pinctrl" + "amlogic,meson-g12a-aobus-pinctrl" + "amlogic,meson-a1-periphs-pinctrl" - reg: address and size of registers controlling irq functionality === GPIO sub-nodes === @@ -21,11 +24,11 @@ GPIO controller. Required properties for sub-nodes are: - - reg: should contain address and size for mux, pull-enable, pull and - gpio register sets - - reg-names: an array of strings describing the "reg" entries. Must - contain "mux", "pull" and "gpio". "pull-enable" is optional and - when it is missing the "pull" registers are used instead + - reg: should contain a list of address and size, one tuple for each entry + in reg-names. + - reg-names: an array of strings describing the "reg" entries. + Must contain "mux" and "gpio". + May contain "pull", "pull-enable" and "ds" when appropriate. - gpio-controller: identifies the node as a gpio controller - #gpio-cells: must be 2 @@ -45,9 +48,19 @@ Required properties for configuration nodes: - pins: a list of pin names -Configuration nodes support the generic properties "bias-disable", -"bias-pull-up" and "bias-pull-down", described in file -pinctrl-bindings.txt +Configuration nodes support the following generic properties, as +described in file pinctrl-bindings.txt: + - "bias-disable" + - "bias-pull-up" + - "bias-pull-down" + - "output-enable" + - "output-disable" + - "output-low" + - "output-high" + +Optional properties : + - drive-strength-microamp: Drive strength for the specified pins in uA. + This property is only valid for G12A and newer. === Example === -- Gitblit v1.6.2