From 8ac6c7a54ed1b98d142dce24b11c6de6a1e239a5 Mon Sep 17 00:00:00 2001
From: hc <hc@nodka.com>
Date: Tue, 22 Oct 2024 10:36:11 +0000
Subject: [PATCH] 修改4g拨号为QMI,需要在系统里后台执行quectel-CM
---
kernel/Documentation/devicetree/bindings/eeprom/at24.txt | 86 ------------------------------------------
1 files changed, 1 insertions(+), 85 deletions(-)
diff --git a/kernel/Documentation/devicetree/bindings/eeprom/at24.txt b/kernel/Documentation/devicetree/bindings/eeprom/at24.txt
index f9a7c98..c94acbb 100644
--- a/kernel/Documentation/devicetree/bindings/eeprom/at24.txt
+++ b/kernel/Documentation/devicetree/bindings/eeprom/at24.txt
@@ -1,85 +1 @@
-EEPROMs (I2C)
-
-Required properties:
-
- - compatible: Must be a "<manufacturer>,<model>" pair. The following <model>
- values are supported (assuming "atmel" as manufacturer):
-
- "atmel,24c00",
- "atmel,24c01",
- "atmel,24cs01",
- "atmel,24c02",
- "atmel,24cs02",
- "atmel,24mac402",
- "atmel,24mac602",
- "atmel,spd",
- "atmel,24c04",
- "atmel,24cs04",
- "atmel,24c08",
- "atmel,24cs08",
- "atmel,24c16",
- "atmel,24cs16",
- "atmel,24c32",
- "atmel,24cs32",
- "atmel,24c64",
- "atmel,24cs64",
- "atmel,24c128",
- "atmel,24c256",
- "atmel,24c512",
- "atmel,24c1024",
- "atmel,24c2048",
-
- If <manufacturer> is not "atmel", then a fallback must be used
- with the same <model> and "atmel" as manufacturer.
-
- Example:
- compatible = "microchip,24c128", "atmel,24c128";
-
- Supported manufacturers are:
-
- "catalyst",
- "microchip",
- "nxp",
- "ramtron",
- "renesas",
- "rohm",
- "st",
-
- Some vendors use different model names for chips which are just
- variants of the above. Known such exceptions are listed below:
-
- "nxp,se97b" - the fallback is "atmel,24c02",
- "renesas,r1ex24002" - the fallback is "atmel,24c02"
- "renesas,r1ex24128" - the fallback is "atmel,24c128"
- "rohm,br24t01" - the fallback is "atmel,24c01"
-
- - reg: The I2C address of the EEPROM.
-
-Optional properties:
-
- - pagesize: The length of the pagesize for writing. Please consult the
- manual of your device, that value varies a lot. A wrong value
- may result in data loss! If not specified, a safety value of
- '1' is used which will be very slow.
-
- - read-only: This parameterless property disables writes to the eeprom.
-
- - size: Total eeprom size in bytes.
-
- - no-read-rollover: This parameterless property indicates that the
- multi-address eeprom does not automatically roll over
- reads to the next slave address. Please consult the
- manual of your device.
-
- - wp-gpios: GPIO to which the write-protect pin of the chip is connected.
-
- - address-width: number of address bits (one of 8, 16).
-
-Example:
-
-eeprom@52 {
- compatible = "atmel,24c32";
- reg = <0x52>;
- pagesize = <32>;
- wp-gpios = <&gpio1 3 0>;
-};
+This file has been moved to at24.yaml.
--
Gitblit v1.6.2