From 1f93a7dfd1f8d5ff7a5c53246c7534fe2332d6f4 Mon Sep 17 00:00:00 2001
From: hc <hc@nodka.com>
Date: Mon, 11 Dec 2023 02:46:07 +0000
Subject: [PATCH] add audio
---
kernel/arch/arm64/boot/dts/rockchip/rk3566-evb1-ddr4-v10.dtsi | 50 ++++++++++++--------------------------------------
1 files changed, 12 insertions(+), 38 deletions(-)
diff --git a/kernel/arch/arm64/boot/dts/rockchip/rk3566-evb1-ddr4-v10.dtsi b/kernel/arch/arm64/boot/dts/rockchip/rk3566-evb1-ddr4-v10.dtsi
index 037cb76..8963446 100644
--- a/kernel/arch/arm64/boot/dts/rockchip/rk3566-evb1-ddr4-v10.dtsi
+++ b/kernel/arch/arm64/boot/dts/rockchip/rk3566-evb1-ddr4-v10.dtsi
@@ -67,11 +67,11 @@
};
&csi2_dphy_hw {
- status = "disabled";
+ status = "okay";
};
&csi2_dphy1 {
- status = "disabled";
+ status = "okay";
/*
* dphy1 only used for split mode,
@@ -108,7 +108,7 @@
};
&csi2_dphy2 {
- status = "disabled";
+ status = "okay";
/*
* dphy2 only used for split mode,
@@ -160,7 +160,7 @@
* when dsi0 is enabled
*/
&dsi0 {
- status = "disabled";
+ status = "okay";
};
&dsi0_in_vp0 {
@@ -168,7 +168,7 @@
};
&dsi0_in_vp1 {
- status = "disabled";
+ status = "okay";
};
&dsi0_panel {
@@ -216,33 +216,6 @@
&edp_in_vp1 {
status = "disabled";
-};
-
-&gmac1 {
- phy-mode = "rgmii";
- clock_in_out = "output";
-
- snps,reset-gpio = <&gpio3 RK_PB0 GPIO_ACTIVE_LOW>;
- snps,reset-active-low;
- /* Reset time is 20ms, 100ms for rtl8211f */
- snps,reset-delays-us = <0 20000 100000>;
-
- assigned-clocks = <&cru SCLK_GMAC1_RX_TX>, <&cru SCLK_GMAC1>;
- assigned-clock-parents = <&cru SCLK_GMAC1_RGMII_SPEED>, <&cru CLK_MAC1_2TOP>;
- assigned-clock-rates = <0>, <125000000>;
-
- pinctrl-names = "default";
- pinctrl-0 = <&gmac1m1_miim
- &gmac1m1_tx_bus2
- &gmac1m1_rx_bus2
- &gmac1m1_rgmii_clk
- &gmac1m1_rgmii_bus>;
-
- tx_delay = <0x4f>;
- rx_delay = <0x26>;
-
- phy-handle = <&rgmii_phy1>;
- status = "okay";
};
/*
@@ -351,7 +324,7 @@
};
&video_phy0 {
- status = "disabled";
+ status = "okay";
};
&video_phy1 {
@@ -401,15 +374,15 @@
};
&rkisp {
- status = "disabled";
+ status = "okay";
};
&rkisp_mmu {
- status = "disabled";
+ status = "okay";
};
&rkisp_vir0 {
- status = "disabled";
+ status = "okay";
port {
#address-cells = <1>;
@@ -423,13 +396,14 @@
};
&route_dsi0 {
- status = "disabled";
+ status = "okay";
connect = <&vp1_out_dsi0>;
};
&sdmmc2 {
max-frequency = <150000000>;
- supports-sdio;
+ no-sd;
+ no-mmc;
bus-width = <4>;
disable-wp;
cap-sd-highspeed;
--
Gitblit v1.6.2