From 071106ecf68c401173c58808b1cf5f68cc50d390 Mon Sep 17 00:00:00 2001
From: hc <hc@nodka.com>
Date: Fri, 05 Jan 2024 08:39:27 +0000
Subject: [PATCH] change wifi driver to cypress

---
 kernel/drivers/nvme/host/Kconfig |   32 ++++++++++++++++++++++++++++++--
 1 files changed, 30 insertions(+), 2 deletions(-)

diff --git a/kernel/drivers/nvme/host/Kconfig b/kernel/drivers/nvme/host/Kconfig
index 88a8b59..494675a 100644
--- a/kernel/drivers/nvme/host/Kconfig
+++ b/kernel/drivers/nvme/host/Kconfig
@@ -1,11 +1,13 @@
+# SPDX-License-Identifier: GPL-2.0-only
 config NVME_CORE
 	tristate
+	select BLK_DEV_INTEGRITY_T10 if BLK_DEV_INTEGRITY
 
 config BLK_DEV_NVME
 	tristate "NVM Express block device"
 	depends on PCI && BLOCK
 	select NVME_CORE
-	---help---
+	help
 	  The NVM Express driver is for solid state drives directly
 	  connected to the PCI or PCI Express bus.  If you know you
 	  don't have one of these, it is safe to answer N.
@@ -16,11 +18,19 @@
 config NVME_MULTIPATH
 	bool "NVMe multipath support"
 	depends on NVME_CORE
-	---help---
+	help
 	   This option enables support for multipath access to NVMe
 	   subsystems.  If this option is enabled only a single
 	   /dev/nvmeXnY device will show up for each NVMe namespaces,
 	   even if it is accessible through multiple controllers.
+
+config NVME_HWMON
+	bool "NVMe hardware monitoring"
+	depends on (NVME_CORE=y && HWMON=y) || (NVME_CORE=m && HWMON)
+	help
+	  This provides support for NVMe hardware monitoring. If enabled,
+	  a hardware monitoring device will be created for each NVMe drive
+	  in the system.
 
 config NVME_FABRICS
 	tristate
@@ -57,3 +67,21 @@
 	  from https://github.com/linux-nvme/nvme-cli.
 
 	  If unsure, say N.
+
+config NVME_TCP
+	tristate "NVM Express over Fabrics TCP host driver"
+	depends on INET
+	depends on BLOCK
+	select NVME_CORE
+	select NVME_FABRICS
+	select CRYPTO
+	select CRYPTO_CRC32C
+	help
+	  This provides support for the NVMe over Fabrics protocol using
+	  the TCP transport.  This allows you to use remote block devices
+	  exported using the NVMe protocol set.
+
+	  To configure a NVMe over Fabrics controller use the nvme-cli tool
+	  from https://github.com/linux-nvme/nvme-cli.
+
+	  If unsure, say N.

--
Gitblit v1.6.2