modify sin led gpio

hc

2024-05-13 9d77db3c730780c8ef5ccd4b66403ff5675cfe4e

 kernel/Documentation/devicetree/bindings/iio/imu/st_lsm6dsx.txt
..
..
@@ -7,11 +7,21 @@
7
7
   "st,lsm6dsl"
8
8
   "st,lsm6dsm"
9
9
   "st,ism330dlc"
10
+  "st,lsm6dso"
11
+  "st,asm330lhh"
12
+  "st,lsm6dsox"
13
+  "st,lsm6dsr"
14
+  "st,lsm6ds3tr-c"
15
+  "st,ism330dhcx"
16
+  "st,lsm9ds1-imu"
17
+  "st,lsm6ds0"
18
+  "st,lsm6dsrx"
10
19
 - reg: i2c address of the sensor / spi cs line
11
20
 
12
21
 Optional properties:
13
22
 - st,drdy-int-pin: the pin on the package that will be used to signal
14
23
   "data ready" (valid values: 1 or 2).
24
+- st,pullups : enable/disable internal i2c controller pullup resistors.
15
25
 - drive-open-drain: the interrupt/data ready line will be configured
16
26
   as open drain, which is useful if several sensors share the same
17
27
   interrupt line. This is a boolean property.
..
..
@@ -23,6 +33,7 @@
23
33
 - interrupts: interrupt mapping for IRQ. It should be configured with
24
34
   flags IRQ_TYPE_LEVEL_HIGH, IRQ_TYPE_EDGE_RISING, IRQ_TYPE_LEVEL_LOW or
25
35
   IRQ_TYPE_EDGE_FALLING.
36
+- wakeup-source: Enables wake up of host system on event.
26
37
 
27
38
   Refer to interrupt-controller/interrupts.txt for generic interrupt
28
39
   client node bindings.