modify sin led gpio

hc

2024-05-13 9d77db3c730780c8ef5ccd4b66403ff5675cfe4e

 kernel/Documentation/devicetree/bindings/display/exynos/exynos_dsim.txt
..
..
@@ -21,6 +21,9 @@
21
21
   - samsung,pll-clock-frequency: specifies frequency of the oscillator clock
22
22
   - #address-cells, #size-cells: should be set respectively to <1> and <0>
23
23
     according to DSI host bindings (see MIPI DSI bindings [1])
24
+  - samsung,burst-clock-frequency: specifies DSI frequency in high-speed burst
25
+    mode
26
+  - samsung,esc-clock-frequency: specifies DSI frequency in escape mode
24
27
 
25
28
 Optional properties:
26
29
   - power-domains: a phandle to DSIM power domain node
..
..
@@ -29,25 +32,9 @@
29
32
   Should contain DSI peripheral nodes (see MIPI DSI bindings [1]).
30
33
 
31
34
 Video interfaces:
32
-  Device node can contain video interface port nodes according to [2].
33
-  The following are properties specific to those nodes:
34
-
35
-  port node inbound:
36
-    - reg: (required) must be 0.
37
-  port node outbound:
38
-    - reg: (required) must be 1.
39
-
40
-  endpoint node connected from mic node (reg = 0):
41
-    - remote-endpoint: specifies the endpoint in mic node. This node is required
42
-		       for Exynos5433 mipi dsi. So mic can access to panel node
43
-		       throughout this dsi node.
44
-  endpoint node connected to panel node (reg = 1):
45
-    - remote-endpoint: specifies the endpoint in panel node. This node is
46
-		       required in all kinds of exynos mipi dsi to represent
47
-		       the connection between mipi dsi and panel.
48
-    - samsung,burst-clock-frequency: specifies DSI frequency in high-speed burst
49
-      mode
50
-    - samsung,esc-clock-frequency: specifies DSI frequency in escape mode
35
+  Device node can contain following video interface port nodes according to [2]:
36
+  0: RGB input,
37
+  1: DSI output
51
38
 
52
39
 [1]: Documentation/devicetree/bindings/display/mipi-dsi-bus.txt
53
40
 [2]: Documentation/devicetree/bindings/media/video-interfaces.txt