~hc/RK356X_SDK_RELEASE.git

..	..	@@ -7,11 +7,12 @@
7	7	- compatible : Should be "microchip,usb251xb" or one of the specific types:
8	8	"microchip,usb2512b", "microchip,usb2512bi", "microchip,usb2513b",
9	9	"microchip,usb2513bi", "microchip,usb2514b", "microchip,usb2514bi",
10		- "microchip,usb2517", "microchip,usb2517i"
	10	+ "microchip,usb2517", "microchip,usb2517i", "microchip,usb2422"
11	11	- reg : I2C address on the selected bus (default is <0x2C>)
12	12
13	13	Optional properties :
14	14	- reset-gpios : Should specify the gpio for hub reset
	15	+ - vdd-supply : Should specify the phandle to the regulator supplying vdd
15	16	- skip-config : Skip Hub configuration, but only send the USB-Attach command
16	17	- vendor-id : Set USB Vendor ID of the hub (16 bit, default is 0x0424)
17	18	- product-id : Set USB Product ID of the hub (16 bit, default depends on type)
..	..	@@ -64,6 +65,8 @@
64	65	- power-on-time-ms : Specifies the time it takes from the time the host
65	66	initiates the power-on sequence to a port until the port has adequate
66	67	power. The value is given in ms in a 0 - 510 range (default is 100ms).
	68	+ - swap-dx-lanes : Specifies the ports which will swap the differential-pair
	69	+ (D+/D-), default is not-swapped.
67	70
68	71	Examples:
69	72	usb2512b@2c {
..	..	@@ -81,4 +84,6 @@
81	84	manufacturer = "Foo";
82	85	product = "Foo-Bar";
83	86	serial = "1234567890A";
	87	+ /* correct misplaced usb connectors on port 1,2 */
	88	+ swap-dx-lanes = <1 2>;
84	89	};