修改4g拨号为QMI,需要在系统里后台执行quectel-CM

hc

2024-10-22 8ac6c7a54ed1b98d142dce24b11c6de6a1e239a5

 kernel/Documentation/devicetree/bindings/sound/davinci-mcasp-audio.txt
..
..
@@ -30,6 +30,11 @@
30
30
 - ti,hwmods : Must be "mcasp<n>", n is controller instance starting 0
31
31
 - tx-num-evt : FIFO levels.
32
32
 - rx-num-evt : FIFO levels.
33
+- dismod : Specify the drive on TX pin during inactive slots
34
+	0 : 3-state
35
+	2 : logic low
36
+	3 : logic high
37
+	Defaults to 'logic low' when the property is not present
33
38
 - sram-size-playback : size of sram to be allocated during playback
34
39
 - sram-size-capture  : size of sram to be allocated during capture
35
40
 - interrupts : Interrupt numbers for McASP
..
..
@@ -39,6 +44,26 @@
39
44
   		 please refer to pinctrl-bindings.txt
40
45
 - fck_parent : Should contain a valid clock name which will be used as parent
41
46
 	       for the McASP fck
47
+- auxclk-fs-ratio: When McASP is bus master indicates the ratio between AUCLK
48
+		   and FS rate if applicable:
49
+		   AUCLK rate = auxclk-fs-ratio * FS rate
50
+
51
+Optional GPIO support:
52
+If any McASP pin need to be used as GPIO then the McASP node must have:
53
+...
54
+  gpio-controller
55
+  #gpio-cells = <2>;
56
+...
57
+
58
+When requesting a GPIO, the first parameter is the PIN index in McASP_P*
59
+registers.
60
+For example to request the AXR2 pin of mcasp8:
61
+function-gpios = <&mcasp8 2 0>;
62
+
63
+Or to request the ACLKR pin of mcasp8:
64
+function-gpios = <&mcasp8 29 0>;
65
+
66
+For generic gpio information, please refer to bindings/gpio/gpio.txt
42
67
 
43
68
 Example:
44
69