forked from ~ljy/RK356X_SDK_RELEASE
blame | history | patch | commit | commitdiff
hc
2024-10-22 8ac6c7a54ed1b98d142dce24b11c6de6a1e239a5 
 kernel/Documentation/devicetree/bindings/eeprom/at24.txt
....@@ -1,85 +1 @@
1
-EEPROMs (I2C)
2
-
3
-Required properties:
4
-
5
-  - compatible: Must be a "<manufacturer>,<model>" pair. The following <model>
6
-                values are supported (assuming "atmel" as manufacturer):
7
-
8
-                "atmel,24c00",
9
-                "atmel,24c01",
10
-                "atmel,24cs01",
11
-                "atmel,24c02",
12
-                "atmel,24cs02",
13
-                "atmel,24mac402",
14
-                "atmel,24mac602",
15
-                "atmel,spd",
16
-                "atmel,24c04",
17
-                "atmel,24cs04",
18
-                "atmel,24c08",
19
-                "atmel,24cs08",
20
-                "atmel,24c16",
21
-                "atmel,24cs16",
22
-                "atmel,24c32",
23
-                "atmel,24cs32",
24
-                "atmel,24c64",
25
-                "atmel,24cs64",
26
-                "atmel,24c128",
27
-                "atmel,24c256",
28
-                "atmel,24c512",
29
-                "atmel,24c1024",
30
-                "atmel,24c2048",
31
-
32
-                If <manufacturer> is not "atmel", then a fallback must be used
33
-                with the same <model> and "atmel" as manufacturer.
34
-
35
-                Example:
36
-                        compatible = "microchip,24c128", "atmel,24c128";
37
-
38
-                Supported manufacturers are:
39
-
40
-                "catalyst",
41
-                "microchip",
42
-                "nxp",
43
-                "ramtron",
44
-                "renesas",
45
-                "rohm",
46
-                "st",
47
-
48
-                Some vendors use different model names for chips which are just
49
-                variants of the above. Known such exceptions are listed below:
50
-
51
-                "nxp,se97b" - the fallback is "atmel,24c02",
52
-                "renesas,r1ex24002" - the fallback is "atmel,24c02"
53
-                "renesas,r1ex24128" - the fallback is "atmel,24c128"
54
-                "rohm,br24t01" - the fallback is "atmel,24c01"
55
-
56
-  - reg: The I2C address of the EEPROM.
57
-
58
-Optional properties:
59
-
60
-  - pagesize: The length of the pagesize for writing. Please consult the
61
-              manual of your device, that value varies a lot. A wrong value
62
-              may result in data loss! If not specified, a safety value of
63
-              '1' is used which will be very slow.
64
-
65
-  - read-only: This parameterless property disables writes to the eeprom.
66
-
67
-  - size: Total eeprom size in bytes.
68
-
69
-  - no-read-rollover: This parameterless property indicates that the
70
-                      multi-address eeprom does not automatically roll over
71
-                      reads to the next slave address. Please consult the
72
-                      manual of your device.
73
-
74
-  - wp-gpios: GPIO to which the write-protect pin of the chip is connected.
75
-
76
-  - address-width: number of address bits (one of 8, 16).
77
-
78
-Example:
79
-
80
-eeprom@52 {
81
-	compatible = "atmel,24c32";
82
-	reg = <0x52>;
83
-	pagesize = <32>;
84
-	wp-gpios = <&gpio1 3 0>;
85
-};
1
+This file has been moved to at24.yaml.