| .. | .. |
|---|
| 1 | 1 | // SPDX-License-Identifier: GPL-2.0 |
|---|
| 2 | 2 | /* |
|---|
| 3 | | - * Dummy driver for Intel's Image Signal Processor found on Bay and Cherry |
|---|
| 4 | | - * Trail devices. The sole purpose of this driver is to allow the ISP to |
|---|
| 5 | | - * be put in D3. |
|---|
| 3 | + * Dummy driver for Intel's Image Signal Processor found on Bay Trail |
|---|
| 4 | + * and Cherry Trail devices. The sole purpose of this driver is to allow |
|---|
| 5 | + * the ISP to be put in D3. |
|---|
| 6 | 6 | * |
|---|
| 7 | 7 | * Copyright (C) 2018 Hans de Goede <hdegoede@redhat.com> |
|---|
| 8 | 8 | * |
|---|
| .. | .. |
|---|
| 36 | 36 | static int isp_set_power(struct pci_dev *dev, bool enable) |
|---|
| 37 | 37 | { |
|---|
| 38 | 38 | unsigned long timeout; |
|---|
| 39 | | - u32 val = enable ? ISPSSPM0_IUNIT_POWER_ON : |
|---|
| 40 | | - ISPSSPM0_IUNIT_POWER_OFF; |
|---|
| 39 | + u32 val = enable ? ISPSSPM0_IUNIT_POWER_ON : ISPSSPM0_IUNIT_POWER_OFF; |
|---|
| 41 | 40 | |
|---|
| 42 | 41 | /* Write to ISPSSPM0 bit[1:0] to power on/off the IUNIT */ |
|---|
| 43 | 42 | iosf_mbi_modify(BT_MBI_UNIT_PMC, MBI_REG_READ, ISPSSPM0, |
|---|
| .. | .. |
|---|
| 45 | 44 | |
|---|
| 46 | 45 | /* |
|---|
| 47 | 46 | * There should be no IUNIT access while power-down is |
|---|
| 48 | | - * in progress HW sighting: 4567865 |
|---|
| 47 | + * in progress. HW sighting: 4567865. |
|---|
| 49 | 48 | * Wait up to 50 ms for the IUNIT to shut down. |
|---|
| 50 | 49 | * And we do the same for power on. |
|---|
| 51 | 50 | */ |
|---|
| 52 | 51 | timeout = jiffies + msecs_to_jiffies(50); |
|---|
| 53 | | - while (1) { |
|---|
| 52 | + do { |
|---|
| 54 | 53 | u32 tmp; |
|---|
| 55 | 54 | |
|---|
| 56 | 55 | /* Wait until ISPSSPM0 bit[25:24] shows the right value */ |
|---|
| 57 | 56 | iosf_mbi_read(BT_MBI_UNIT_PMC, MBI_REG_READ, ISPSSPM0, &tmp); |
|---|
| 58 | 57 | tmp = (tmp & ISPSSPM0_ISPSSS_MASK) >> ISPSSPM0_ISPSSS_OFFSET; |
|---|
| 59 | 58 | if (tmp == val) |
|---|
| 60 | | - break; |
|---|
| 59 | + return 0; |
|---|
| 61 | 60 | |
|---|
| 62 | | - if (time_after(jiffies, timeout)) { |
|---|
| 63 | | - dev_err(&dev->dev, "IUNIT power-%s timeout.\n", |
|---|
| 64 | | - enable ? "on" : "off"); |
|---|
| 65 | | - return -EBUSY; |
|---|
| 66 | | - } |
|---|
| 67 | 61 | usleep_range(1000, 2000); |
|---|
| 68 | | - } |
|---|
| 62 | + } while (time_before(jiffies, timeout)); |
|---|
| 69 | 63 | |
|---|
| 70 | | - return 0; |
|---|
| 64 | + dev_err(&dev->dev, "IUNIT power-%s timeout.\n", enable ? "on" : "off"); |
|---|
| 65 | + return -EBUSY; |
|---|
| 71 | 66 | } |
|---|
| 72 | 67 | |
|---|
| 73 | 68 | static int isp_probe(struct pci_dev *dev, const struct pci_device_id *id) |
|---|