change system file

hc

2024-10-09 244b2c5ca8b14627e4a17755e5922221e121c771

 kernel/Documentation/devicetree/bindings/pinctrl/brcm,bcm2835-gpio.txt
..
..
@@ -5,13 +5,20 @@
5
5
 
6
6
 Required properties:
7
7
 - compatible: "brcm,bcm2835-gpio"
8
+- compatible: should be one of:
9
+  "brcm,bcm2835-gpio" - BCM2835 compatible pinctrl
10
+  "brcm,bcm7211-gpio" - BCM7211 compatible pinctrl
11
+  "brcm,bcm2711-gpio" - BCM2711 compatible pinctrl
12
+  "brcm,bcm7211-gpio" - BCM7211 compatible pinctrl
8
13
 - reg: Should contain the physical address of the GPIO module's registers.
9
14
 - gpio-controller: Marks the device node as a GPIO controller.
10
15
 - #gpio-cells : Should be two. The first cell is the pin number and the
11
16
   second cell is used to specify optional parameters:
12
17
   - bit 0 specifies polarity (0 for normal, 1 for inverted)
13
18
 - interrupts : The interrupt outputs from the controller. One interrupt per
14
-  individual bank followed by the "all banks" interrupt.
19
+  individual bank followed by the "all banks" interrupt. For BCM7211, an
20
+  additional set of per-bank interrupt line and an "all banks" wake-up
21
+  interrupt may be specified.
15
22
 - interrupt-controller: Marks the device node as an interrupt controller.
16
23
 - #interrupt-cells : Should be 2.
17
24
   The first cell is the GPIO number.