| .. | .. |
|---|
| 1 | +# SPDX-License-Identifier: GPL-2.0-only |
|---|
| 1 | 2 | # |
|---|
| 2 | 3 | # Qualcomm network device configuration |
|---|
| 3 | 4 | # |
|---|
| .. | .. |
|---|
| 5 | 6 | config NET_VENDOR_QUALCOMM |
|---|
| 6 | 7 | bool "Qualcomm devices" |
|---|
| 7 | 8 | default y |
|---|
| 8 | | - ---help--- |
|---|
| 9 | + help |
|---|
| 9 | 10 | If you have a network (Ethernet) card belonging to this class, say Y. |
|---|
| 10 | 11 | |
|---|
| 11 | 12 | Note that the answer to this question doesn't directly affect the |
|---|
| .. | .. |
|---|
| 24 | 25 | tristate "Qualcomm Atheros QCA7000 SPI support" |
|---|
| 25 | 26 | select QCA7000 |
|---|
| 26 | 27 | depends on SPI_MASTER && OF |
|---|
| 27 | | - ---help--- |
|---|
| 28 | + help |
|---|
| 28 | 29 | This SPI protocol driver supports the Qualcomm Atheros QCA7000. |
|---|
| 29 | 30 | |
|---|
| 30 | 31 | To compile this driver as a module, choose M here. The module |
|---|
| .. | .. |
|---|
| 34 | 35 | tristate "Qualcomm Atheros QCA7000 UART support" |
|---|
| 35 | 36 | select QCA7000 |
|---|
| 36 | 37 | depends on SERIAL_DEV_BUS && OF |
|---|
| 37 | | - ---help--- |
|---|
| 38 | + help |
|---|
| 38 | 39 | This UART protocol driver supports the Qualcomm Atheros QCA7000. |
|---|
| 39 | 40 | |
|---|
| 40 | 41 | Currently the driver assumes these device UART settings: |
|---|
| .. | .. |
|---|
| 51 | 52 | depends on HAS_DMA && HAS_IOMEM |
|---|
| 52 | 53 | select CRC32 |
|---|
| 53 | 54 | select PHYLIB |
|---|
| 54 | | - ---help--- |
|---|
| 55 | + help |
|---|
| 55 | 56 | This driver supports the Qualcomm Technologies, Inc. Gigabit |
|---|
| 56 | 57 | Ethernet Media Access Controller (EMAC). The controller |
|---|
| 57 | 58 | supports IEEE 802.3-2002, half-duplex mode at 10/100 Mb/s, |
|---|