/******************************************************************************
|
*
|
* Copyright (C) 2012-2014 Broadcom Corporation
|
*
|
* Licensed under the Apache License, Version 2.0 (the "License");
|
* you may not use this file except in compliance with the License.
|
* You may obtain a copy of the License at:
|
*
|
* http://www.apache.org/licenses/LICENSE-2.0
|
*
|
* Unless required by applicable law or agreed to in writing, software
|
* distributed under the License is distributed on an "AS IS" BASIS,
|
* WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
|
* See the License for the specific language governing permissions and
|
* limitations under the License.
|
*
|
******************************************************************************/
|
|
#ifndef NFC_HAL_TARGET_H
|
#define NFC_HAL_TARGET_H
|
|
#include "data_types.h"
|
#include "gki.h"
|
|
/****************************************************************************
|
** NCI related configuration
|
****************************************************************************/
|
|
/* Initial Max Control Packet Payload Size (until receiving payload size in
|
* INIT_CORE_RSP) */
|
#ifndef NFC_HAL_NCI_INIT_CTRL_PAYLOAD_SIZE
|
#define NFC_HAL_NCI_INIT_CTRL_PAYLOAD_SIZE 0xFF
|
#endif
|
|
/* Number of bytes to reserve in front of NCI messages (e.g. for transport
|
* header) */
|
#ifndef NFC_HAL_NCI_MSG_OFFSET_SIZE
|
#define NFC_HAL_NCI_MSG_OFFSET_SIZE 1
|
#endif
|
|
/* NFC-WAKE */
|
#ifndef NFC_HAL_LP_NFC_WAKE_GPIO
|
#define NFC_HAL_LP_NFC_WAKE_GPIO UPIO_GENERAL3
|
#endif
|
|
/* NFCC snooze mode idle timeout before deassert NFC_WAKE in ms */
|
#ifndef NFC_HAL_LP_IDLE_TIMEOUT
|
#define NFC_HAL_LP_IDLE_TIMEOUT 100
|
#endif
|
|
/* NFC snooze mode */
|
#ifndef NFC_HAL_LP_SNOOZE_MODE
|
#define NFC_HAL_LP_SNOOZE_MODE NFC_HAL_LP_SNOOZE_MODE_UART
|
#endif
|
|
/* Idle Threshold Host in 100ms unit */
|
#ifndef NFC_HAL_LP_IDLE_THRESHOLD_HOST
|
#define NFC_HAL_LP_IDLE_THRESHOLD_HOST 0
|
#endif
|
|
/* Idle Threshold HC in 100ms unit */
|
#ifndef NFC_HAL_LP_IDLE_THRESHOLD_HC
|
#define NFC_HAL_LP_IDLE_THRESHOLD_HC 0
|
#endif
|
|
/* Default NFCC power-up baud rate */
|
#ifndef NFC_HAL_DEFAULT_BAUD
|
#define NFC_HAL_DEFAULT_BAUD USERIAL_BAUD_115200
|
#endif
|
|
/* time (in ms) between power off and on NFCC */
|
#ifndef NFC_HAL_POWER_CYCLE_DELAY
|
#define NFC_HAL_POWER_CYCLE_DELAY 100
|
#endif
|
|
/* time (in ms) between power off and on NFCC */
|
#ifndef NFC_HAL_NFCC_ENABLE_TIMEOUT
|
#define NFC_HAL_NFCC_ENABLE_TIMEOUT 1000
|
#endif
|
|
#ifndef NFC_HAL_PRM_DEBUG
|
#define NFC_HAL_PRM_DEBUG TRUE
|
#endif
|
|
/* max patch data length (Can be overridden by platform for ACL HCI command
|
* size) */
|
#ifndef NFC_HAL_PRM_HCD_CMD_MAXLEN
|
#define NFC_HAL_PRM_HCD_CMD_MAXLEN 250
|
#endif
|
|
/* Require PreI2C patch by default */
|
#ifndef NFC_HAL_PRE_I2C_PATCH_INCLUDED
|
#define NFC_HAL_PRE_I2C_PATCH_INCLUDED TRUE
|
#endif
|
|
/* over-riden for platforms that have transport packet limitations */
|
#ifndef NFC_HAL_PRM_MIN_NCI_CMD_PAYLOAD_SIZE
|
#define NFC_HAL_PRM_MIN_NCI_CMD_PAYLOAD_SIZE (32)
|
#endif
|
|
/* amount of time to wait for authenticating/committing patch to NVM */
|
#ifndef NFC_HAL_PRM_COMMIT_DELAY
|
#define NFC_HAL_PRM_COMMIT_DELAY (30000)
|
#endif
|
|
/* amount of time to wait after downloading preI2C patch before downloading
|
* LPM/FPM patch */
|
#ifndef NFC_HAL_PRM_POST_I2C_FIX_DELAY
|
#define NFC_HAL_PRM_POST_I2C_FIX_DELAY (200)
|
#endif
|
|
/* NFCC will respond to more than one technology during listen discovery */
|
#ifndef NFC_HAL_DM_MULTI_TECH_RESP
|
#define NFC_HAL_DM_MULTI_TECH_RESP TRUE
|
#endif
|
|
/* Data rate for 15693 command/response, it must be same as
|
* RW_I93_FLAG_DATA_RATE in nfc_target.h */
|
#define NFC_HAL_I93_FLAG_DATA_RATE_HIGH 0x02
|
|
#ifndef NFC_HAL_I93_FLAG_DATA_RATE
|
#define NFC_HAL_I93_FLAG_DATA_RATE NFC_HAL_I93_FLAG_DATA_RATE_HIGH
|
#endif
|
|
/* NFC HAL HCI */
|
#ifndef NFC_HAL_HCI_INCLUDED
|
#define NFC_HAL_HCI_INCLUDED TRUE
|
#endif
|
|
/* Quick Timer */
|
#ifndef QUICK_TIMER_TICKS_PER_SEC
|
#define QUICK_TIMER_TICKS_PER_SEC 100 /* 10ms timer */
|
#endif
|
|
#ifndef NFC_HAL_SHARED_TRANSPORT_ENABLED
|
#define NFC_HAL_SHARED_TRANSPORT_ENABLED FALSE
|
#endif
|
|
/* Enable verbose tracing by default */
|
#ifndef NFC_HAL_TRACE_VERBOSE
|
#define NFC_HAL_TRACE_VERBOSE TRUE
|
#endif
|
|
#ifndef NFC_HAL_INITIAL_TRACE_LEVEL
|
#define NFC_HAL_INITIAL_TRACE_LEVEL 5
|
#endif
|
|
/* Map NFC serial port to USERIAL_PORT_6 by default */
|
#ifndef USERIAL_NFC_PORT
|
#define USERIAL_NFC_PORT (USERIAL_PORT_6)
|
#endif
|
|
/* Restore NFCC baud rate to default on shutdown if baud rate was updated */
|
#ifndef NFC_HAL_RESTORE_BAUD_ON_SHUTDOWN
|
#define NFC_HAL_RESTORE_BAUD_ON_SHUTDOWN TRUE
|
#endif
|
|
/* Enable protocol tracing by default */
|
#ifndef NFC_HAL_TRACE_PROTOCOL
|
#define NFC_HAL_TRACE_PROTOCOL TRUE
|
#endif
|
|
#endif /* GKI_TARGET_H */
|
