/*
|
* atmel platform data
|
*
|
* GPL v2 Only
|
*/
|
|
#ifndef __ATMEL_H__
|
#define __ATMEL_H__
|
|
#include <linux/mtd/nand.h>
|
#include <linux/mtd/partitions.h>
|
#include <linux/serial.h>
|
|
/* Compact Flash */
|
struct at91_cf_data {
|
int irq_pin; /* I/O IRQ */
|
int det_pin; /* Card detect */
|
int vcc_pin; /* power switching */
|
int rst_pin; /* card reset */
|
u8 chipselect; /* EBI Chip Select number */
|
u8 flags;
|
#define AT91_CF_TRUE_IDE 0x01
|
#define AT91_IDE_SWAP_A0_A2 0x02
|
};
|
|
/* NAND / SmartMedia */
|
struct atmel_nand_data {
|
int enable_pin; /* chip enable */
|
int det_pin; /* card detect */
|
int rdy_pin; /* ready/busy */
|
u8 rdy_pin_active_low; /* rdy_pin value is inverted */
|
u8 ale; /* address line number connected to ALE */
|
u8 cle; /* address line number connected to CLE */
|
u8 bus_width_16; /* buswidth is 16 bit */
|
u8 ecc_mode; /* ecc mode */
|
u8 on_flash_bbt; /* bbt on flash */
|
struct mtd_partition *parts;
|
unsigned int num_parts;
|
bool has_dma; /* support dma transfer */
|
|
/* default is false, only for at32ap7000 chip is true */
|
bool need_reset_workaround;
|
};
|
|
/* Serial */
|
struct atmel_uart_data {
|
int num; /* port num */
|
short use_dma_tx; /* use transmit DMA? */
|
short use_dma_rx; /* use receive DMA? */
|
void __iomem *regs; /* virt. base address, if any */
|
struct serial_rs485 rs485; /* rs485 settings */
|
};
|
|
/* FIXME: this needs a better location, but gets stuff building again */
|
extern int at91_suspend_entering_slow_clock(void);
|
|
#endif /* __ATMEL_H__ */
|
