/* SPDX-License-Identifier: GPL-2.0-or-later */
|
/***************************************************************************
|
*
|
* Copyright (C) 2004-2008 SMSC
|
* Copyright (C) 2005-2008 ARM
|
*
|
***************************************************************************/
|
#ifndef __LINUX_SMSC911X_H__
|
#define __LINUX_SMSC911X_H__
|
|
#include <linux/phy.h>
|
#include <linux/if_ether.h>
|
|
/* platform_device configuration data, should be assigned to
|
* the platform_device's dev.platform_data */
|
struct smsc911x_platform_config {
|
unsigned int irq_polarity;
|
unsigned int irq_type;
|
unsigned int flags;
|
unsigned int shift;
|
phy_interface_t phy_interface;
|
unsigned char mac[ETH_ALEN];
|
};
|
|
/* Constants for platform_device irq polarity configuration */
|
#define SMSC911X_IRQ_POLARITY_ACTIVE_LOW 0
|
#define SMSC911X_IRQ_POLARITY_ACTIVE_HIGH 1
|
|
/* Constants for platform_device irq type configuration */
|
#define SMSC911X_IRQ_TYPE_OPEN_DRAIN 0
|
#define SMSC911X_IRQ_TYPE_PUSH_PULL 1
|
|
/* Constants for flags */
|
#define SMSC911X_USE_16BIT (BIT(0))
|
#define SMSC911X_USE_32BIT (BIT(1))
|
#define SMSC911X_FORCE_INTERNAL_PHY (BIT(2))
|
#define SMSC911X_FORCE_EXTERNAL_PHY (BIT(3))
|
#define SMSC911X_SAVE_MAC_ADDRESS (BIT(4))
|
|
/*
|
* SMSC911X_SWAP_FIFO:
|
* Enables software byte swap for fifo data. Should only be used as a
|
* "last resort" in the case of big endian mode on boards with incorrectly
|
* routed data bus to older devices such as LAN9118. Newer devices such as
|
* LAN9221 can handle this in hardware, there are registers to control
|
* this swapping but the driver doesn't currently use them.
|
*/
|
#define SMSC911X_SWAP_FIFO (BIT(5))
|
|
#endif /* __LINUX_SMSC911X_H__ */
|
