/*
|
* SchulerControl GmbH, SC_SPS_1 module config
|
*
|
* Copyright (C) 2012 Marek Vasut <marex@denx.de>
|
* on behalf of DENX Software Engineering GmbH
|
*
|
* SPDX-License-Identifier: GPL-2.0+
|
*/
|
#ifndef __CONFIGS_SC_SPS_1_H__
|
#define __CONFIGS_SC_SPS_1_H__
|
|
/* System configuration */
|
#define CONFIG_MX28 /* i.MX28 SoC */
|
#define CONFIG_MACH_TYPE MACH_TYPE_SC_SPS_1
|
|
/* U-Boot Commands */
|
|
/* Memory configuration */
|
#define CONFIG_NR_DRAM_BANKS 1 /* 1 bank of DRAM */
|
#define PHYS_SDRAM_1 0x40000000 /* Base address */
|
#define PHYS_SDRAM_1_SIZE 0x40000000 /* Max 1 GB RAM */
|
#define CONFIG_SYS_SDRAM_BASE PHYS_SDRAM_1
|
|
/* Environment */
|
#define CONFIG_ENV_SIZE (16 * 1024)
|
|
/* Environment is in MMC */
|
#if defined(CONFIG_CMD_MMC) && defined(CONFIG_ENV_IS_IN_MMC)
|
#define CONFIG_ENV_OFFSET (256 * 1024)
|
#define CONFIG_SYS_MMC_ENV_DEV 0
|
#endif
|
|
/* FEC Ethernet on SoC */
|
#ifdef CONFIG_CMD_NET
|
#define CONFIG_FEC_MXC
|
#define CONFIG_PHY_SMSC
|
#endif
|
|
/* USB */
|
#ifdef CONFIG_CMD_USB
|
#define CONFIG_EHCI_MXS_PORT0
|
#define CONFIG_USB_MAX_CONTROLLER_COUNT 1
|
#endif
|
|
/* Booting Linux */
|
#define CONFIG_BOOTFILE "uImage"
|
#define CONFIG_BOOTCOMMAND "bootm"
|
#define CONFIG_LOADADDR 0x42000000
|
#define CONFIG_SYS_LOAD_ADDR CONFIG_LOADADDR
|
|
/* Extra Environment */
|
#define CONFIG_EXTRA_ENV_SETTINGS \
|
"update_sd_firmware_filename=u-boot.sd\0" \
|
"update_sd_firmware=" /* Update the SD firmware partition */ \
|
"if mmc rescan ; then " \
|
"if tftp ${update_sd_firmware_filename} ; then " \
|
"setexpr fw_sz ${filesize} / 0x200 ; " /* SD block size */ \
|
"setexpr fw_sz ${fw_sz} + 1 ; " \
|
"mmc write ${loadaddr} 0x800 ${fw_sz} ; " \
|
"fi ; " \
|
"fi\0"
|
|
/* The rest of the configuration is shared */
|
#include <configs/mxs.h>
|
|
#endif /* __CONFIGS_SC_SPS_1_H__ */
|
