/*
|
* Copyright 2016 Freescale Semiconductor
|
*
|
* SPDX-License-Identifier: GPL-2.0+
|
*/
|
|
#ifndef __LS1046ARDB_H__
|
#define __LS1046ARDB_H__
|
|
#include "ls1046a_common.h"
|
|
#ifdef CONFIG_SD_BOOT
|
#define CONFIG_SYS_TEXT_BASE 0x82000000
|
#else
|
#define CONFIG_SYS_TEXT_BASE 0x40100000
|
#endif
|
|
#define CONFIG_SYS_CLK_FREQ 100000000
|
#define CONFIG_DDR_CLK_FREQ 100000000
|
|
#define CONFIG_LAYERSCAPE_NS_ACCESS
|
#define CONFIG_MISC_INIT_R
|
|
#define CONFIG_DIMM_SLOTS_PER_CTLR 1
|
/* Physical Memory Map */
|
#define CONFIG_CHIP_SELECTS_PER_CTRL 4
|
#define CONFIG_NR_DRAM_BANKS 2
|
|
#define CONFIG_DDR_SPD
|
#define SPD_EEPROM_ADDRESS 0x51
|
#define CONFIG_SYS_SPD_BUS_NUM 0
|
|
#define CONFIG_DDR_ECC
|
#define CONFIG_ECC_INIT_VIA_DDRCONTROLLER
|
#define CONFIG_MEM_INIT_VALUE 0xdeadbeef
|
#define CONFIG_FSL_DDR_BIST /* enable built-in memory test */
|
#ifndef CONFIG_SPL
|
#define CONFIG_FSL_DDR_INTERACTIVE /* Interactive debugging */
|
#endif
|
|
#ifdef CONFIG_RAMBOOT_PBL
|
#define CONFIG_SYS_FSL_PBL_PBI board/freescale/ls1046ardb/ls1046ardb_pbi.cfg
|
#endif
|
|
#ifdef CONFIG_SD_BOOT
|
#ifdef CONFIG_EMMC_BOOT
|
#define CONFIG_SYS_FSL_PBL_RCW \
|
board/freescale/ls1046ardb/ls1046ardb_rcw_emmc.cfg
|
#else
|
#define CONFIG_SYS_FSL_PBL_RCW board/freescale/ls1046ardb/ls1046ardb_rcw_sd.cfg
|
#endif
|
#endif
|
|
#ifndef SPL_NO_IFC
|
/* IFC */
|
#define CONFIG_FSL_IFC
|
/*
|
* NAND Flash Definitions
|
*/
|
#define CONFIG_NAND_FSL_IFC
|
#endif
|
|
#define CONFIG_SYS_NAND_BASE 0x7e800000
|
#define CONFIG_SYS_NAND_BASE_PHYS CONFIG_SYS_NAND_BASE
|
|
#define CONFIG_SYS_NAND_CSPR_EXT (0x0)
|
#define CONFIG_SYS_NAND_CSPR (CSPR_PHYS_ADDR(CONFIG_SYS_NAND_BASE_PHYS) \
|
| CSPR_PORT_SIZE_8 \
|
| CSPR_MSEL_NAND \
|
| CSPR_V)
|
#define CONFIG_SYS_NAND_AMASK IFC_AMASK(64 * 1024)
|
#define CONFIG_SYS_NAND_CSOR (CSOR_NAND_ECC_ENC_EN /* ECC on encode */ \
|
| CSOR_NAND_ECC_DEC_EN /* ECC on decode */ \
|
| CSOR_NAND_ECC_MODE_8 /* 8-bit ECC */ \
|
| CSOR_NAND_RAL_3 /* RAL = 3 Bytes */ \
|
| CSOR_NAND_PGS_4K /* Page Size = 4K */ \
|
| CSOR_NAND_SPRZ_224 /* Spare size = 224 */ \
|
| CSOR_NAND_PB(64)) /* 64 Pages Per Block */
|
|
#define CONFIG_SYS_NAND_ONFI_DETECTION
|
|
#define CONFIG_SYS_NAND_FTIM0 (FTIM0_NAND_TCCST(0x7) | \
|
FTIM0_NAND_TWP(0x18) | \
|
FTIM0_NAND_TWCHT(0x7) | \
|
FTIM0_NAND_TWH(0xa))
|
#define CONFIG_SYS_NAND_FTIM1 (FTIM1_NAND_TADLE(0x32) | \
|
FTIM1_NAND_TWBE(0x39) | \
|
FTIM1_NAND_TRR(0xe) | \
|
FTIM1_NAND_TRP(0x18))
|
#define CONFIG_SYS_NAND_FTIM2 (FTIM2_NAND_TRAD(0xf) | \
|
FTIM2_NAND_TREH(0xa) | \
|
FTIM2_NAND_TWHRE(0x1e))
|
#define CONFIG_SYS_NAND_FTIM3 0x0
|
|
#define CONFIG_SYS_NAND_BASE_LIST { CONFIG_SYS_NAND_BASE }
|
#define CONFIG_SYS_MAX_NAND_DEVICE 1
|
#define CONFIG_MTD_NAND_VERIFY_WRITE
|
|
#define CONFIG_SYS_NAND_BLOCK_SIZE (128 * 1024)
|
|
/*
|
* CPLD
|
*/
|
#define CONFIG_SYS_CPLD_BASE 0x7fb00000
|
#define CPLD_BASE_PHYS CONFIG_SYS_CPLD_BASE
|
|
#define CONFIG_SYS_CPLD_CSPR_EXT (0x0)
|
#define CONFIG_SYS_CPLD_CSPR (CSPR_PHYS_ADDR(CPLD_BASE_PHYS) | \
|
CSPR_PORT_SIZE_8 | \
|
CSPR_MSEL_GPCM | \
|
CSPR_V)
|
#define CONFIG_SYS_CPLD_AMASK IFC_AMASK(64 * 1024)
|
#define CONFIG_SYS_CPLD_CSOR CSOR_NOR_ADM_SHIFT(16)
|
|
/* CPLD Timing parameters for IFC GPCM */
|
#define CONFIG_SYS_CPLD_FTIM0 (FTIM0_GPCM_TACSE(0x0e) | \
|
FTIM0_GPCM_TEADC(0x0e) | \
|
FTIM0_GPCM_TEAHC(0x0e))
|
#define CONFIG_SYS_CPLD_FTIM1 (FTIM1_GPCM_TACO(0xff) | \
|
FTIM1_GPCM_TRAD(0x3f))
|
#define CONFIG_SYS_CPLD_FTIM2 (FTIM2_GPCM_TCS(0xf) | \
|
FTIM2_GPCM_TCH(0xf) | \
|
FTIM2_GPCM_TWP(0x3E))
|
#define CONFIG_SYS_CPLD_FTIM3 0x0
|
|
/* IFC Timing Params */
|
#define CONFIG_SYS_CSPR0_EXT CONFIG_SYS_NAND_CSPR_EXT
|
#define CONFIG_SYS_CSPR0 CONFIG_SYS_NAND_CSPR
|
#define CONFIG_SYS_AMASK0 CONFIG_SYS_NAND_AMASK
|
#define CONFIG_SYS_CSOR0 CONFIG_SYS_NAND_CSOR
|
#define CONFIG_SYS_CS0_FTIM0 CONFIG_SYS_NAND_FTIM0
|
#define CONFIG_SYS_CS0_FTIM1 CONFIG_SYS_NAND_FTIM1
|
#define CONFIG_SYS_CS0_FTIM2 CONFIG_SYS_NAND_FTIM2
|
#define CONFIG_SYS_CS0_FTIM3 CONFIG_SYS_NAND_FTIM3
|
|
#define CONFIG_SYS_CSPR2_EXT CONFIG_SYS_CPLD_CSPR_EXT
|
#define CONFIG_SYS_CSPR2 CONFIG_SYS_CPLD_CSPR
|
#define CONFIG_SYS_AMASK2 CONFIG_SYS_CPLD_AMASK
|
#define CONFIG_SYS_CSOR2 CONFIG_SYS_CPLD_CSOR
|
#define CONFIG_SYS_CS2_FTIM0 CONFIG_SYS_CPLD_FTIM0
|
#define CONFIG_SYS_CS2_FTIM1 CONFIG_SYS_CPLD_FTIM1
|
#define CONFIG_SYS_CS2_FTIM2 CONFIG_SYS_CPLD_FTIM2
|
#define CONFIG_SYS_CS2_FTIM3 CONFIG_SYS_CPLD_FTIM3
|
|
/* EEPROM */
|
#define CONFIG_ID_EEPROM
|
#define CONFIG_SYS_I2C_EEPROM_NXID
|
#define CONFIG_SYS_EEPROM_BUS_NUM 0
|
#define CONFIG_SYS_I2C_EEPROM_ADDR 0x53
|
#define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 1
|
#define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 3
|
#define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 5
|
#define I2C_RETIMER_ADDR 0x18
|
|
/* PMIC */
|
#define CONFIG_POWER
|
#ifdef CONFIG_POWER
|
#define CONFIG_POWER_I2C
|
#endif
|
|
/*
|
* Environment
|
*/
|
#ifndef SPL_NO_ENV
|
#define CONFIG_ENV_OVERWRITE
|
#endif
|
|
#if defined(CONFIG_SD_BOOT)
|
#define CONFIG_SYS_MMC_ENV_DEV 0
|
#define CONFIG_ENV_OFFSET (3 * 1024 * 1024)
|
#define CONFIG_ENV_SIZE 0x2000
|
#else
|
#define CONFIG_ENV_SIZE 0x2000 /* 8KB */
|
#define CONFIG_ENV_OFFSET 0x300000 /* 3MB */
|
#define CONFIG_ENV_SECT_SIZE 0x40000 /* 256KB */
|
#endif
|
|
#define AQR105_IRQ_MASK 0x80000000
|
/* FMan */
|
#ifndef SPL_NO_FMAN
|
|
#ifdef CONFIG_NET
|
#define CONFIG_PHY_REALTEK
|
#endif
|
|
#ifdef CONFIG_SYS_DPAA_FMAN
|
#define CONFIG_FMAN_ENET
|
#define CONFIG_PHY_AQUANTIA
|
#define CONFIG_PHYLIB_10G
|
#define RGMII_PHY1_ADDR 0x1
|
#define RGMII_PHY2_ADDR 0x2
|
|
#define SGMII_PHY1_ADDR 0x3
|
#define SGMII_PHY2_ADDR 0x4
|
|
#define FM1_10GEC1_PHY_ADDR 0x0
|
|
#define CONFIG_ETHPRIME "FM1@DTSEC3"
|
#endif
|
|
#endif
|
|
/* QSPI device */
|
#ifndef SPL_NO_QSPI
|
#ifdef CONFIG_FSL_QSPI
|
#define CONFIG_SPI_FLASH_SPANSION
|
#define FSL_QSPI_FLASH_SIZE (1 << 26)
|
#define FSL_QSPI_FLASH_NUM 2
|
#endif
|
#endif
|
|
/* USB */
|
#ifndef SPL_NO_USB
|
#define CONFIG_HAS_FSL_XHCI_USB
|
#ifdef CONFIG_HAS_FSL_XHCI_USB
|
#define CONFIG_USB_XHCI_FSL
|
#define CONFIG_USB_MAX_CONTROLLER_COUNT 3
|
#endif
|
#endif
|
|
/* SATA */
|
#ifndef SPL_NO_SATA
|
#define CONFIG_LIBATA
|
#define CONFIG_SCSI_AHCI
|
#define CONFIG_SCSI_AHCI_PLAT
|
|
#define CONFIG_SYS_SATA AHCI_BASE_ADDR
|
|
#define CONFIG_SYS_SCSI_MAX_SCSI_ID 1
|
#define CONFIG_SYS_SCSI_MAX_LUN 1
|
#define CONFIG_SYS_SCSI_MAX_DEVICE (CONFIG_SYS_SCSI_MAX_SCSI_ID * \
|
CONFIG_SYS_SCSI_MAX_LUN)
|
#endif
|
|
#ifndef SPL_NO_MISC
|
#undef CONFIG_BOOTCOMMAND
|
#define CONFIG_BOOTCOMMAND "run distro_bootcmd; env exists secureboot" \
|
"&& esbc_halt; run qspi_bootcmd;"
|
#define MTDPARTS_DEFAULT "mtdparts=1550000.quadspi:1m(rcw)," \
|
"15m(u-boot),48m(kernel.itb);" \
|
"7e800000.flash:16m(nand_uboot)," \
|
"48m(nand_kernel),448m(nand_free)"
|
#endif
|
|
#include <asm/fsl_secure_boot.h>
|
|
#endif /* __LS1046ARDB_H__ */
|
