/*
|
* Copyright 2016 Freescale Semiconductor
|
*
|
* SPDX-License-Identifier: GPL-2.0+
|
*/
|
|
#ifndef __LS1012A_COMMON_H
|
#define __LS1012A_COMMON_H
|
|
#define CONFIG_FSL_LAYERSCAPE
|
#define CONFIG_GICV2
|
|
#include <asm/arch/config.h>
|
#include <asm/arch/stream_id_lsch2.h>
|
|
#define CONFIG_SUPPORT_RAW_INITRD
|
|
#define CONFIG_DISPLAY_BOARDINFO_LATE
|
|
#define CONFIG_SYS_TEXT_BASE 0x40100000
|
|
#define CONFIG_SYS_CLK_FREQ 125000000
|
|
#define CONFIG_SKIP_LOWLEVEL_INIT
|
|
#define CONFIG_SYS_INIT_SP_ADDR (CONFIG_SYS_FSL_OCRAM_BASE + 0xfff0)
|
#define CONFIG_SYS_LOAD_ADDR (CONFIG_SYS_DDR_SDRAM_BASE + 0x10000000)
|
|
#define CONFIG_SYS_DDR_SDRAM_BASE 0x80000000
|
#define CONFIG_SYS_FSL_DDR_SDRAM_BASE_PHY 0
|
#define CONFIG_SYS_SDRAM_BASE CONFIG_SYS_DDR_SDRAM_BASE
|
#define CONFIG_SYS_DDR_BLOCK2_BASE 0x880000000ULL
|
|
/* Generic Timer Definitions */
|
#define COUNTER_FREQUENCY CONFIG_SYS_CLK_FREQ/4 /* 25MHz */
|
|
/* CSU */
|
#define CONFIG_LAYERSCAPE_NS_ACCESS
|
|
/* Size of malloc() pool */
|
#define CONFIG_SYS_MALLOC_LEN (CONFIG_ENV_SIZE + 128 * 1024)
|
|
/*SPI device */
|
#ifdef CONFIG_QSPI_BOOT
|
#define CONFIG_SYS_QE_FW_IN_SPIFLASH
|
#define CONFIG_SYS_FMAN_FW_ADDR 0x400d0000
|
#define CONFIG_ENV_SPI_BUS 0
|
#define CONFIG_ENV_SPI_CS 0
|
#define CONFIG_ENV_SPI_MAX_HZ 1000000
|
#define CONFIG_ENV_SPI_MODE 0x03
|
#define CONFIG_SPI_FLASH_SPANSION
|
#define CONFIG_FSL_SPI_INTERFACE
|
#define CONFIG_SF_DATAFLASH
|
|
#define CONFIG_FSL_QSPI
|
#define QSPI0_AMBA_BASE 0x40000000
|
#define CONFIG_SPI_FLASH_SPANSION
|
|
#define FSL_QSPI_FLASH_SIZE SZ_64M
|
#define FSL_QSPI_FLASH_NUM 2
|
|
/*
|
* Environment
|
*/
|
#define CONFIG_ENV_OVERWRITE
|
|
#define CONFIG_ENV_SIZE 0x40000 /* 256KB */
|
#define CONFIG_ENV_OFFSET 0x200000 /* 2MB */
|
#define CONFIG_ENV_SECT_SIZE 0x40000
|
#endif
|
|
/* I2C */
|
#define CONFIG_SYS_I2C
|
#define CONFIG_SYS_I2C_MXC
|
#define CONFIG_SYS_I2C_MXC_I2C1 /* enable I2C bus 1 */
|
#define CONFIG_SYS_I2C_MXC_I2C2 /* enable I2C bus 2 */
|
|
#define CONFIG_CONS_INDEX 1
|
#define CONFIG_SYS_NS16550_SERIAL
|
#define CONFIG_SYS_NS16550_REG_SIZE 1
|
#define CONFIG_SYS_NS16550_CLK (get_serial_clock())
|
|
#define CONFIG_SYS_BAUDRATE_TABLE { 9600, 19200, 38400, 57600, 115200 }
|
|
/* Command line configuration */
|
#undef CONFIG_CMD_IMLS
|
|
#define CONFIG_SYS_HZ 1000
|
|
#define CONFIG_HWCONFIG
|
#define HWCONFIG_BUFFER_SIZE 128
|
|
/* Initial environment variables */
|
#define CONFIG_EXTRA_ENV_SETTINGS \
|
"verify=no\0" \
|
"loadaddr=0x80100000\0" \
|
"kernel_addr=0x100000\0" \
|
"fdt_high=0xffffffffffffffff\0" \
|
"initrd_high=0xffffffffffffffff\0" \
|
"kernel_start=0xa00000\0" \
|
"kernel_load=0xa0000000\0" \
|
"kernel_size=0x2800000\0" \
|
|
#define CONFIG_BOOTCOMMAND "sf probe 0:0; sf read $kernel_load "\
|
"$kernel_start $kernel_size && "\
|
"bootm $kernel_load"
|
|
/* Monitor Command Prompt */
|
#define CONFIG_SYS_CBSIZE 512 /* Console I/O Buffer Size */
|
#define CONFIG_SYS_LONGHELP
|
#define CONFIG_CMDLINE_EDITING 1
|
#define CONFIG_AUTO_COMPLETE
|
#define CONFIG_SYS_MAXARGS 64 /* max command args */
|
|
#define CONFIG_SYS_BOOTM_LEN (64 << 20) /* Increase max gunzip size */
|
|
#include <asm/arch/soc.h>
|
|
#endif /* __LS1012A_COMMON_H */
|
