/*
|
* Config file for Compulab CM-T54 board
|
*
|
* Copyright (C) 2014, Compulab Ltd - http://compulab.co.il/
|
*
|
* Author: Dmitry Lifshitz <lifshitz@compulab.co.il>
|
*
|
* SPDX-License-Identifier: GPL-2.0+
|
*/
|
|
#ifndef __CONFIG_CM_T54_H
|
#define __CONFIG_CM_T54_H
|
|
#define CONFIG_CM_T54
|
#define CONFIG_DRAM_2G
|
|
#include <configs/ti_omap5_common.h>
|
|
/* EEPROM related defines */
|
#define CONFIG_SYS_I2C_EEPROM_ADDR 0x50
|
#define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 1
|
#define CONFIG_SYS_I2C_EEPROM_BUS 0
|
|
/* Enable SD/MMC CD and WP GPIOs */
|
#define OMAP_HSMMC_USE_GPIO
|
|
/* UART setup */
|
#define CONFIG_CONS_INDEX 4
|
#define CONFIG_SYS_NS16550_COM4 UART4_BASE
|
|
/* MMC ENV related defines */
|
#undef CONFIG_ENV_OFFSET
|
#undef CONFIG_ENV_SIZE
|
|
#define CONFIG_SYS_MMC_ENV_DEV 1 /* SLOT2: eMMC(1) */
|
#define CONFIG_SYS_MMC_ENV_PART 0
|
#define CONFIG_ENV_OFFSET 0xc0000 /* (in bytes) 768 KB */
|
#define CONFIG_ENV_SIZE (16 << 10) /* 16 KB */
|
#define CONFIG_ENV_OFFSET_REDUND (CONFIG_ENV_OFFSET + CONFIG_ENV_SIZE)
|
#define CONFIG_SYS_REDUNDAND_ENVIRONMENT
|
|
/* Enhance our eMMC support / experience. */
|
#define CONFIG_HSMMC2_8BIT
|
#define CONFIG_SUPPORT_EMMC_BOOT
|
|
/* SATA Boot related defines */
|
#define CONFIG_SPL_SATA_BOOT_DEVICE 0
|
#define CONFIG_SYS_SATA_FAT_BOOT_PARTITION 1
|
|
#define CONFIG_LIBATA
|
#define CONFIG_SCSI_AHCI
|
#define CONFIG_SCSI_AHCI_PLAT
|
#define CONFIG_SYS_SCSI_MAX_SCSI_ID 1
|
#define CONFIG_SYS_SCSI_MAX_LUN 1
|
#define CONFIG_SYS_SCSI_MAX_DEVICE (CONFIG_SYS_SCSI_MAX_SCSI_ID * \
|
CONFIG_SYS_SCSI_MAX_LUN)
|
/* USB UHH support options */
|
#define CONFIG_EHCI_HCD_INIT_AFTER_RESET
|
|
#define CONFIG_OMAP_EHCI_PHY2_RESET_GPIO 76 /* HSIC2 HUB #RESET */
|
#define CONFIG_OMAP_EHCI_PHY3_RESET_GPIO 83 /* HSIC3 ETH #RESET */
|
|
/* Enabled commands */
|
|
/* EEPROM */
|
#define CONFIG_ENV_EEPROM_IS_ON_I2C
|
#define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 1
|
#define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 4
|
#define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 5
|
#define CONFIG_SYS_EEPROM_SIZE 256
|
|
/* USB Networking options */
|
|
/*
|
* Miscellaneous configurable options
|
*/
|
#undef CONFIG_SYS_AUTOLOAD
|
#undef CONFIG_EXTRA_ENV_SETTINGS
|
#undef CONFIG_BOOTCOMMAND
|
|
#define CONFIG_SYS_AUTOLOAD "no"
|
|
#define CONFIG_EXTRA_ENV_SETTINGS \
|
DEFAULT_LINUX_BOOT_ENV \
|
"baudrate=115200\0" \
|
"bootdelay=3\0" \
|
"autoload=no\0" \
|
"bootscr=bootscr.img\0" \
|
"fdtfile=omap5-sbc-t54.dtb\0" \
|
"kernel=zImage-cm-t54\0" \
|
"ramdisk=ramdisk-cm-t54.img\0" \
|
"console=ttyO3\0" \
|
"ramdisksize=16384\0" \
|
"mmcdev=0\0" \
|
"mmcroot=/dev/mmcblk1p2\0" \
|
"mmcargs=setenv bootargs console=${console} " \
|
"root=${mmcroot} rw rootwait\0" \
|
"ramroot=/dev/ram0\0" \
|
"ramargs=setenv bootargs console=${console} " \
|
"root=${ramroot} ramdisk_size=${ramdisksize} rw\0" \
|
"mmcloadkernel=load mmc ${mmcdev} ${loadaddr} ${kernel}\0" \
|
"mmcloadfdt=load mmc ${mmcdev} ${fdtaddr} ${fdtfile}\0" \
|
"mmcloadramdisk=load mmc ${mmcdev} ${rdaddr} ${ramdisk}\0" \
|
"mmcloadbootscript=load mmc ${mmcdev} ${loadaddr} ${bootsrc}\0" \
|
"mmcbootscript=echo Running bootscript from mmc${mmcdev}...; " \
|
"source ${loadaddr}\0" \
|
"mmcbootlinux=echo Booting from mmc${mmcdev} ...; " \
|
"bootz ${loadaddr} ${rdaddr} ${fdtaddr}\0" \
|
"mmcboot=if mmc dev ${mmcdev} && mmc rescan; then " \
|
"if run mmcloadbootscript; " \
|
"then run mmcbootscript; " \
|
"fi; " \
|
"if run mmcloadkernel; then " \
|
"if run mmcloadfdt; then " \
|
"if run mmcloadramdisk; then " \
|
"run ramargs; " \
|
"run mmcbootlinux; " \
|
"fi; " \
|
"run mmcargs; " \
|
"setenv rdaddr - ; " \
|
"run mmcbootlinux; " \
|
"fi; " \
|
"fi; " \
|
"fi;\0"
|
|
#define CONFIG_BOOTCOMMAND \
|
"bootcmd=run mmcboot || setenv mmcdev 1; setenv mmcroot /dev/mmcblk0p2; run mmcboot;"
|
|
#endif /* __CONFIG_CM_T54_H */
|
