/*
|
* Copyright (c) 2017 Toradex, Inc.
|
*
|
* Configuration settings for the Toradex Apalis TK1 modules.
|
*
|
* SPDX-License-Identifier: GPL-2.0+
|
*/
|
|
#ifndef __CONFIG_H
|
#define __CONFIG_H
|
|
#include <linux/sizes.h>
|
|
#include "tegra124-common.h"
|
|
#define CONFIG_ARCH_MISC_INIT
|
|
/* High-level configuration options */
|
#define CONFIG_DISPLAY_BOARDINFO_LATE /* Calls show_board_info() */
|
|
/* Board-specific serial config */
|
#define CONFIG_TEGRA_ENABLE_UARTA
|
#define CONFIG_SYS_NS16550_COM1 NV_PA_APB_UARTA_BASE
|
|
/* I2C */
|
#define CONFIG_SYS_I2C_TEGRA
|
|
/* SD/MMC support */
|
#define CONFIG_SUPPORT_EMMC_BOOT /* eMMC specific */
|
|
/* Environment in eMMC, before config block at the end of 1st "boot sector" */
|
#define CONFIG_ENV_OFFSET (-CONFIG_ENV_SIZE + \
|
CONFIG_TDX_CFG_BLOCK_OFFSET)
|
#define CONFIG_SYS_MMC_ENV_DEV 0
|
#define CONFIG_SYS_MMC_ENV_PART 1
|
|
/* USB host support */
|
#define CONFIG_USB_EHCI_TEGRA
|
|
/* PCI host support */
|
#undef CONFIG_PCI_SCAN_SHOW
|
|
/* PCI networking support */
|
#define CONFIG_E1000_NO_NVM
|
|
/* General networking support */
|
#define CONFIG_IP_DEFRAG
|
#define CONFIG_TFTP_BLOCKSIZE 16352
|
#define CONFIG_TFTP_TSIZE
|
|
#undef CONFIG_IPADDR
|
#define CONFIG_IPADDR 192.168.10.2
|
#define CONFIG_NETMASK 255.255.255.0
|
#undef CONFIG_SERVERIP
|
#define CONFIG_SERVERIP 192.168.10.1
|
|
#define CONFIG_BOOTCOMMAND \
|
"run emmcboot; setenv fdtfile ${soc}-apalis-${fdt_board}.dtb && " \
|
"run distro_bootcmd"
|
|
#define DFU_ALT_EMMC_INFO "apalis-tk1.img raw 0x0 0x500 mmcpart 1; " \
|
"boot part 0 1 mmcpart 0; " \
|
"rootfs part 0 2 mmcpart 0; " \
|
"uImage fat 0 1 mmcpart 0; " \
|
"tegra124-apalis-eval.dtb fat 0 1 mmcpart 0"
|
|
#define EMMC_BOOTCMD \
|
"emmcargs=ip=off root=/dev/mmcblk0p2 rw rootfstype=ext3 rootwait\0" \
|
"emmcboot=run setup; setenv bootargs ${defargs} ${emmcargs} " \
|
"${setupargs} ${vidargs}; echo Booting from internal eMMC " \
|
"chip...; run emmcdtbload; load mmc 0:1 ${kernel_addr_r} " \
|
"${boot_file} && run fdt_fixup && " \
|
"bootm ${kernel_addr_r} - ${dtbparam}\0" \
|
"emmcdtbload=setenv dtbparam; load mmc 0:1 ${fdt_addr_r} " \
|
"${soc}-apalis-${fdt_board}.dtb && " \
|
"setenv dtbparam ${fdt_addr_r}\0"
|
|
#define NFS_BOOTCMD \
|
"nfsargs=ip=:::::eth0:on root=/dev/nfs rw\0" \
|
"nfsboot=pci enum; run setup; setenv bootargs ${defargs} ${nfsargs} " \
|
"${setupargs} ${vidargs}; echo Booting via DHCP/TFTP/NFS...; " \
|
"run nfsdtbload; dhcp ${kernel_addr_r} " \
|
"&& run fdt_fixup && bootm ${kernel_addr_r} - ${dtbparam}\0" \
|
"nfsdtbload=setenv dtbparam; tftp ${fdt_addr_r} " \
|
"${soc}-apalis-${fdt_board}.dtb " \
|
"&& setenv dtbparam ${fdt_addr_r}\0"
|
|
#define SD_BOOTCMD \
|
"sdargs=ip=off root=/dev/mmcblk1p2 rw rootfstype=ext3 rootwait\0" \
|
"sdboot=run setup; setenv bootargs ${defargs} ${sdargs} ${setupargs} " \
|
"${vidargs}; echo Booting from SD card in 8bit slot...; " \
|
"run sddtbload; load mmc 1:1 ${kernel_addr_r} " \
|
"${boot_file} && run fdt_fixup && " \
|
"bootm ${kernel_addr_r} - ${dtbparam}\0" \
|
"sddtbload=setenv dtbparam; load mmc 1:1 ${fdt_addr_r} " \
|
"${soc}-apalis-${fdt_board}.dtb " \
|
"&& setenv dtbparam ${fdt_addr_r}\0"
|
|
#define USB_BOOTCMD \
|
"usbargs=ip=off root=/dev/sda2 rw rootfstype=ext3 rootwait\0" \
|
"usbboot=run setup; setenv bootargs ${defargs} ${setupargs} " \
|
"${usbargs} ${vidargs}; echo Booting from USB stick...; " \
|
"usb start && run usbdtbload; load usb 0:1 ${kernel_addr_r} " \
|
"${boot_file} && run fdt_fixup && " \
|
"bootm ${kernel_addr_r} - ${dtbparam}\0" \
|
"usbdtbload=setenv dtbparam; load usb 0:1 ${fdt_addr_r} " \
|
"${soc}-apalis-${fdt_board}.dtb " \
|
"&& setenv dtbparam ${fdt_addr_r}\0"
|
|
#define BOARD_EXTRA_ENV_SETTINGS \
|
"boot_file=uImage\0" \
|
"console=ttyS0\0" \
|
"defargs=lp0_vec=2064@0xf46ff000 core_edp_mv=1150 core_edp_ma=4000 " \
|
"usb_port_owner_info=2 lane_owner_info=6 emc_max_dvfs=0\0" \
|
"dfu_alt_info=" DFU_ALT_EMMC_INFO "\0" \
|
EMMC_BOOTCMD \
|
"fdt_board=eval\0" \
|
"fdt_fixup=;\0" \
|
NFS_BOOTCMD \
|
SD_BOOTCMD \
|
"setethupdate=if env exists ethaddr; then; else setenv ethaddr " \
|
"00:14:2d:00:00:00; fi; pci enum && tftpboot ${loadaddr} " \
|
"flash_eth.img && source ${loadaddr}\0" \
|
"setsdupdate=setenv interface mmc; setenv drive 1; mmc rescan; " \
|
"load ${interface} ${drive}:1 ${loadaddr} flash_blk.img " \
|
"|| setenv drive 2; mmc rescan; load ${interface} ${drive}:1 " \
|
"${loadaddr} flash_blk.img && " \
|
"source ${loadaddr}\0" \
|
"setup=setenv setupargs igb_mac=${ethaddr} " \
|
"consoleblank=0 no_console_suspend=1 console=tty1 " \
|
"console=${console},${baudrate}n8 debug_uartport=lsport,0 " \
|
"${memargs}\0" \
|
"setupdate=run setsdupdate || run setusbupdate || run setethupdate\0" \
|
"setusbupdate=usb start && setenv interface usb; setenv drive 0; " \
|
"load ${interface} ${drive}:1 ${loadaddr} flash_blk.img && " \
|
"source ${loadaddr}\0" \
|
USB_BOOTCMD \
|
"vidargs=video=tegrafb0:640x480-16@60 fbcon=map:1\0"
|
|
/* Increase console I/O buffer size */
|
#undef CONFIG_SYS_CBSIZE
|
#define CONFIG_SYS_CBSIZE 1024
|
|
/* Increase arguments buffer size */
|
#undef CONFIG_SYS_BARGSIZE
|
#define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE
|
|
/* Increase maximum number of arguments */
|
#undef CONFIG_SYS_MAXARGS
|
#define CONFIG_SYS_MAXARGS 32
|
|
#define CONFIG_CMD_TIME
|
|
#define CONFIG_SUPPORT_RAW_INITRD
|
#define CONFIG_SYS_BOOT_RAMDISK_HIGH
|
|
#include "tegra-common-usb-gadget.h"
|
#include "tegra-common-post.h"
|
|
/* Reserve top 1M for secure RAM */
|
#define CONFIG_ARMV7_SECURE_BASE 0xfff00000
|
#define CONFIG_ARMV7_SECURE_RESERVE_SIZE 0x00100000
|
|
#endif /* __CONFIG_H */
|
