/* SPDX-License-Identifier: GPL-2.0-only */
|
/*
|
* Copyright(c) 2007 Intel Corporation. All rights reserved.
|
*
|
* Maintained at www.Open-FCoE.org
|
*/
|
|
#ifndef _FC_FCP_H_
|
#define _FC_FCP_H_
|
|
#include <scsi/scsi.h>
|
|
/*
|
* Fibre Channel Protocol for SCSI.
|
* From T10 FCP-3, T10 project 1560-D Rev 4, Sept. 13, 2005.
|
*/
|
|
/*
|
* fc/fs.h defines FC_TYPE_FCP.
|
*/
|
|
/*
|
* Service parameter page parameters (word 3 bits) for Process Login.
|
*/
|
#define FCP_SPPF_TASK_RETRY_ID 0x0200 /* task retry ID requested */
|
#define FCP_SPPF_RETRY 0x0100 /* retry supported */
|
#define FCP_SPPF_CONF_COMPL 0x0080 /* confirmed completion allowed */
|
#define FCP_SPPF_OVLY_ALLOW 0x0040 /* data overlay allowed */
|
#define FCP_SPPF_INIT_FCN 0x0020 /* initiator function */
|
#define FCP_SPPF_TARG_FCN 0x0010 /* target function */
|
#define FCP_SPPF_RD_XRDY_DIS 0x0002 /* disable XFER_RDY for reads */
|
#define FCP_SPPF_WR_XRDY_DIS 0x0001 /* disable XFER_RDY for writes */
|
|
/*
|
* FCP_CMND IU Payload.
|
*/
|
struct fcp_cmnd {
|
struct scsi_lun fc_lun; /* logical unit number */
|
__u8 fc_cmdref; /* command reference number */
|
__u8 fc_pri_ta; /* priority and task attribute */
|
__u8 fc_tm_flags; /* task management flags */
|
__u8 fc_flags; /* additional len & flags */
|
__u8 fc_cdb[16]; /* base CDB */
|
__be32 fc_dl; /* data length (must follow fc_cdb) */
|
};
|
|
#define FCP_CMND_LEN 32 /* expected length of structure */
|
|
struct fcp_cmnd32 {
|
struct scsi_lun fc_lun; /* logical unit number */
|
__u8 fc_cmdref; /* command reference number */
|
__u8 fc_pri_ta; /* priority and task attribute */
|
__u8 fc_tm_flags; /* task management flags */
|
__u8 fc_flags; /* additional len & flags */
|
__u8 fc_cdb[32]; /* base CDB */
|
__be32 fc_dl; /* data length (must follow fc_cdb) */
|
};
|
|
#define FCP_CMND32_LEN 48 /* expected length of structure */
|
#define FCP_CMND32_ADD_LEN (16 / 4) /* Additional cdb length */
|
|
/*
|
* fc_pri_ta.
|
*/
|
#define FCP_PTA_SIMPLE 0 /* simple task attribute */
|
#define FCP_PTA_HEADQ 1 /* head of queue task attribute */
|
#define FCP_PTA_ORDERED 2 /* ordered task attribute */
|
#define FCP_PTA_ACA 4 /* auto. contingent allegiance */
|
#define FCP_PTA_MASK 7 /* mask for task attribute field */
|
#define FCP_PRI_SHIFT 3 /* priority field starts in bit 3 */
|
#define FCP_PRI_RESVD_MASK 0x80 /* reserved bits in priority field */
|
|
/*
|
* fc_tm_flags - task management flags field.
|
*/
|
#define FCP_TMF_CLR_ACA 0x40 /* clear ACA condition */
|
#define FCP_TMF_TGT_RESET 0x20 /* target reset task management,
|
deprecated as of FCP-3 */
|
#define FCP_TMF_LUN_RESET 0x10 /* logical unit reset task management */
|
#define FCP_TMF_CLR_TASK_SET 0x04 /* clear task set */
|
#define FCP_TMF_ABT_TASK_SET 0x02 /* abort task set */
|
|
/*
|
* fc_flags.
|
* Bits 7:2 are the additional FCP_CDB length / 4.
|
*/
|
#define FCP_CFL_LEN_MASK 0xfc /* mask for additional length */
|
#define FCP_CFL_LEN_SHIFT 2 /* shift bits for additional length */
|
#define FCP_CFL_RDDATA 0x02 /* read data */
|
#define FCP_CFL_WRDATA 0x01 /* write data */
|
|
/*
|
* FCP_TXRDY IU - transfer ready payload.
|
*/
|
struct fcp_txrdy {
|
__be32 ft_data_ro; /* data relative offset */
|
__be32 ft_burst_len; /* burst length */
|
__u8 _ft_resvd[4]; /* reserved */
|
};
|
|
#define FCP_TXRDY_LEN 12 /* expected length of structure */
|
|
/*
|
* FCP_RESP IU - response payload.
|
*
|
* The response payload comes in three parts: the flags/status, the
|
* sense/response lengths and the sense data/response info section.
|
*
|
* From FCP3r04, note 6 of section 9.5.13:
|
*
|
* Some early implementations presented the FCP_RSP IU without the FCP_RESID,
|
* FCP_SNS_LEN, and FCP_RSP_LEN fields if the FCP_RESID_UNDER, FCP_RESID_OVER,
|
* FCP_SNS_LEN_VALID, and FCP_RSP_LEN_VALID bits were all set to zero. This
|
* non-standard behavior should be tolerated.
|
*
|
* All response frames will always contain the fcp_resp template. Some
|
* will also include the fcp_resp_len template.
|
*
|
* From Table 23, the FCP_RSP_INFO can either be 4 bytes or 8 bytes, both
|
* are valid length.
|
*/
|
struct fcp_resp {
|
__u8 _fr_resvd[8]; /* reserved */
|
__be16 fr_retry_delay; /* retry delay timer */
|
__u8 fr_flags; /* flags */
|
__u8 fr_status; /* SCSI status code */
|
};
|
|
#define FCP_RESP_LEN 12 /* expected length of structure */
|
|
struct fcp_resp_ext {
|
__be32 fr_resid; /* Residual value */
|
__be32 fr_sns_len; /* SCSI Sense length */
|
__be32 fr_rsp_len; /* Response Info length */
|
|
/*
|
* Optionally followed by RSP info and/or SNS info and/or
|
* bidirectional read residual length, if any.
|
*/
|
};
|
|
#define FCP_RESP_EXT_LEN 12 /* expected length of the structure */
|
|
struct fcp_resp_rsp_info {
|
__u8 _fr_resvd[3]; /* reserved */
|
__u8 rsp_code; /* Response Info Code */
|
__u8 _fr_resvd2[4]; /* reserved */
|
};
|
|
#define FCP_RESP_RSP_INFO_LEN4 4 /* without reserved field */
|
#define FCP_RESP_RSP_INFO_LEN8 8 /* with reserved field */
|
|
struct fcp_resp_with_ext {
|
struct fcp_resp resp;
|
struct fcp_resp_ext ext;
|
};
|
|
#define FCP_RESP_WITH_EXT (FCP_RESP_LEN + FCP_RESP_EXT_LEN)
|
|
/*
|
* fr_flags.
|
*/
|
#define FCP_BIDI_RSP 0x80 /* bidirectional read response */
|
#define FCP_BIDI_READ_UNDER 0x40 /* bidir. read less than requested */
|
#define FCP_BIDI_READ_OVER 0x20 /* DL insufficient for full transfer */
|
#define FCP_CONF_REQ 0x10 /* confirmation requested */
|
#define FCP_RESID_UNDER 0x08 /* transfer shorter than expected */
|
#define FCP_RESID_OVER 0x04 /* DL insufficient for full transfer */
|
#define FCP_SNS_LEN_VAL 0x02 /* SNS_LEN field is valid */
|
#define FCP_RSP_LEN_VAL 0x01 /* RSP_LEN field is valid */
|
|
/*
|
* rsp_codes
|
*/
|
enum fcp_resp_rsp_codes {
|
FCP_TMF_CMPL = 0,
|
FCP_DATA_LEN_INVALID = 1,
|
FCP_CMND_FIELDS_INVALID = 2,
|
FCP_DATA_PARAM_MISMATCH = 3,
|
FCP_TMF_REJECTED = 4,
|
FCP_TMF_FAILED = 5,
|
FCP_TMF_INVALID_LUN = 9,
|
};
|
|
/*
|
* FCP SRR Link Service request - Sequence Retransmission Request.
|
*/
|
struct fcp_srr {
|
__u8 srr_op; /* opcode ELS_SRR */
|
__u8 srr_resvd[3]; /* opcode / reserved - must be zero */
|
__be16 srr_ox_id; /* OX_ID of failed command */
|
__be16 srr_rx_id; /* RX_ID of failed command */
|
__be32 srr_rel_off; /* relative offset */
|
__u8 srr_r_ctl; /* r_ctl for the information unit */
|
__u8 srr_resvd2[3]; /* reserved */
|
};
|
|
/*
|
* Feature bits in name server FC-4 Features object.
|
*/
|
#define FCP_FEAT_TARG (1 << 0) /* target function supported */
|
#define FCP_FEAT_INIT (1 << 1) /* initiator function supported */
|
|
#endif /* _FC_FCP_H_ */
|
