How to use U-Boot on Freescale MX6UL 14x14 EVK
|
-----------------------------------------------
|
|
- Build U-Boot for MX6UL 14x14 EVK:
|
|
$ make mrproper
|
$ make mx6ul_14x14_evk_defconfig
|
$ make
|
|
This will generate the SPL image called SPL and the u-boot.img.
|
|
- Flash the SPL image into the micro SD card:
|
|
sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync
|
|
- Flash the u-boot.img image into the micro SD card:
|
|
sudo dd if=u-boot.img of=/dev/mmcblk0 bs=1k seek=69; sync
|
|
- Jumper settings:
|
|
SW601: 0 0 1 0
|
Sw602: 1 0
|
|
where 0 means bottom position and 1 means top position (from the
|
switch label numbers reference).
|
|
- Connect the USB cable between the EVK and the PC for the console.
|
(The USB console connector is the one close the push buttons)
|
|
- Insert the micro SD card in the board, power it up and U-Boot messages should
|
come up.
|
