# SPDX-License-Identifier: GPL-2.0
|
#
|
# Makefile for the Linux kernel device drivers.
|
#
|
# 15 Sep 2000, Christoph Hellwig <hch@infradead.org>
|
# Rewritten to use lists instead of if-statements.
|
#
|
|
obj-y += irqchip/
|
obj-y += bus/
|
|
obj-$(CONFIG_GENERIC_PHY) += phy/
|
|
# GPIO must come after pinctrl as gpios may need to mux pins etc
|
obj-$(CONFIG_PINCTRL) += pinctrl/
|
obj-$(CONFIG_GPIOLIB) += gpio/
|
obj-y += pwm/
|
|
obj-y += pci/
|
|
obj-$(CONFIG_PARISC) += parisc/
|
obj-$(CONFIG_RAPIDIO) += rapidio/
|
obj-y += video/
|
obj-y += idle/
|
|
# IPMI must come before ACPI in order to provide IPMI opregion support
|
obj-y += char/ipmi/
|
|
obj-$(CONFIG_ACPI) += acpi/
|
obj-$(CONFIG_SFI) += sfi/
|
# PnP must come after ACPI since it will eventually need to check if acpi
|
# was used and do nothing if so
|
obj-$(CONFIG_PNP) += pnp/
|
obj-y += amba/
|
|
obj-y += clk/
|
# Many drivers will want to use DMA so this has to be made available
|
# really early.
|
obj-$(CONFIG_DMADEVICES) += dma/
|
|
# SOC specific infrastructure drivers.
|
obj-y += soc/
|
|
obj-$(CONFIG_VIRTIO) += virtio/
|
obj-$(CONFIG_VDPA) += vdpa/
|
obj-$(CONFIG_XEN) += xen/
|
|
# regulators early, since some subsystems rely on them to initialize
|
obj-$(CONFIG_REGULATOR) += regulator/
|
|
# reset controllers early, since gpu drivers might rely on them to initialize
|
obj-$(CONFIG_RESET_CONTROLLER) += reset/
|
|
# tty/ comes before char/ so that the VT console is the boot-time
|
# default.
|
obj-y += tty/
|
obj-y += char/
|
|
# iommu/ comes before gpu as gpu are using iommu controllers
|
obj-y += iommu/
|
|
# gpu/ comes after char for AGP vs DRM startup and after iommu
|
obj-y += gpu/
|
|
obj-$(CONFIG_CONNECTOR) += connector/
|
|
# i810fb and intelfb depend on char/agp/
|
obj-$(CONFIG_FB_I810) += video/fbdev/i810/
|
obj-$(CONFIG_FB_INTEL) += video/fbdev/intelfb/
|
|
obj-$(CONFIG_PARPORT) += parport/
|
obj-$(CONFIG_NVM) += lightnvm/
|
obj-y += base/ block/ misc/ mfd/ nfc/
|
obj-$(CONFIG_LIBNVDIMM) += nvdimm/
|
obj-$(CONFIG_DAX) += dax/
|
obj-$(CONFIG_DMA_SHARED_BUFFER) += dma-buf/
|
obj-$(CONFIG_NUBUS) += nubus/
|
obj-y += macintosh/
|
obj-$(CONFIG_IDE) += ide/
|
obj-y += scsi/
|
obj-y += nvme/
|
obj-$(CONFIG_ATA) += ata/
|
obj-$(CONFIG_TARGET_CORE) += target/
|
obj-$(CONFIG_MTD) += mtd/
|
obj-$(CONFIG_SPI) += spi/
|
obj-$(CONFIG_SPMI) += spmi/
|
obj-$(CONFIG_HSI) += hsi/
|
obj-$(CONFIG_SLIMBUS) += slimbus/
|
obj-y += net/
|
obj-$(CONFIG_ATM) += atm/
|
obj-$(CONFIG_FUSION) += message/
|
obj-y += firewire/
|
obj-$(CONFIG_UIO) += uio/
|
obj-$(CONFIG_VFIO) += vfio/
|
obj-y += cdrom/
|
obj-y += auxdisplay/
|
obj-$(CONFIG_PCCARD) += pcmcia/
|
obj-$(CONFIG_DIO) += dio/
|
obj-$(CONFIG_SBUS) += sbus/
|
obj-$(CONFIG_ZORRO) += zorro/
|
obj-$(CONFIG_ATA_OVER_ETH) += block/aoe/
|
obj-$(CONFIG_PARIDE) += block/paride/
|
obj-$(CONFIG_TC) += tc/
|
obj-$(CONFIG_USB_PHY) += usb/
|
obj-$(CONFIG_USB) += usb/
|
obj-$(CONFIG_USB_SUPPORT) += usb/
|
obj-$(CONFIG_PCI) += usb/
|
obj-$(CONFIG_USB_GADGET) += usb/
|
obj-$(CONFIG_OF) += usb/
|
obj-$(CONFIG_SERIO) += input/serio/
|
obj-$(CONFIG_GAMEPORT) += input/gameport/
|
obj-$(CONFIG_INPUT) += input/
|
obj-$(CONFIG_RTC_LIB) += rtc/
|
obj-y += i2c/ i3c/ media/
|
obj-$(CONFIG_PPS) += pps/
|
obj-y += ptp/
|
obj-$(CONFIG_W1) += w1/
|
obj-y += power/
|
obj-$(CONFIG_HWMON) += hwmon/
|
obj-$(CONFIG_THERMAL) += thermal/
|
obj-$(CONFIG_WATCHDOG) += watchdog/
|
obj-$(CONFIG_MD) += md/
|
obj-$(CONFIG_BT) += bluetooth/
|
obj-$(CONFIG_ACCESSIBILITY) += accessibility/
|
obj-$(CONFIG_ISDN) += isdn/
|
obj-$(CONFIG_EDAC) += edac/
|
obj-$(CONFIG_EISA) += eisa/
|
obj-$(CONFIG_PM_OPP) += opp/
|
obj-$(CONFIG_CPU_FREQ) += cpufreq/
|
obj-$(CONFIG_CPU_IDLE) += cpuidle/
|
obj-y += mmc/
|
obj-$(CONFIG_MEMSTICK) += memstick/
|
obj-$(CONFIG_NEW_LEDS) += leds/
|
obj-$(CONFIG_INFINIBAND) += infiniband/
|
obj-y += firmware/
|
obj-$(CONFIG_CRYPTO) += crypto/
|
obj-$(CONFIG_SUPERH) += sh/
|
ifndef CONFIG_ARCH_USES_GETTIMEOFFSET
|
obj-y += clocksource/
|
endif
|
obj-$(CONFIG_DCA) += dca/
|
obj-$(CONFIG_HID) += hid/
|
obj-$(CONFIG_PPC_PS3) += ps3/
|
obj-$(CONFIG_OF) += of/
|
obj-$(CONFIG_SSB) += ssb/
|
obj-$(CONFIG_BCMA) += bcma/
|
obj-$(CONFIG_VHOST_RING) += vhost/
|
obj-$(CONFIG_VHOST_IOTLB) += vhost/
|
obj-$(CONFIG_VHOST) += vhost/
|
obj-$(CONFIG_VLYNQ) += vlynq/
|
obj-$(CONFIG_GREYBUS) += greybus/
|
obj-$(CONFIG_STAGING) += staging/
|
obj-y += platform/
|
|
obj-$(CONFIG_MAILBOX) += mailbox/
|
obj-$(CONFIG_HWSPINLOCK) += hwspinlock/
|
obj-$(CONFIG_REMOTEPROC) += remoteproc/
|
obj-$(CONFIG_RPMSG) += rpmsg/
|
obj-$(CONFIG_SOUNDWIRE) += soundwire/
|
|
# Virtualization drivers
|
obj-$(CONFIG_VIRT_DRIVERS) += virt/
|
obj-$(CONFIG_HYPERV) += hv/
|
|
obj-$(CONFIG_PM_DEVFREQ) += devfreq/
|
obj-$(CONFIG_EXTCON) += extcon/
|
obj-$(CONFIG_MEMORY) += memory/
|
obj-$(CONFIG_IIO) += iio/
|
obj-$(CONFIG_VME_BUS) += vme/
|
obj-$(CONFIG_IPACK_BUS) += ipack/
|
obj-$(CONFIG_NTB) += ntb/
|
obj-$(CONFIG_POWERCAP) += powercap/
|
obj-$(CONFIG_MCB) += mcb/
|
obj-$(CONFIG_PERF_EVENTS) += perf/
|
obj-$(CONFIG_RAS) += ras/
|
obj-$(CONFIG_USB4) += thunderbolt/
|
obj-$(CONFIG_CORESIGHT) += hwtracing/coresight/
|
obj-y += hwtracing/intel_th/
|
obj-$(CONFIG_STM) += hwtracing/stm/
|
obj-$(CONFIG_ANDROID) += android/
|
obj-$(CONFIG_NVMEM) += nvmem/
|
obj-$(CONFIG_FPGA) += fpga/
|
obj-$(CONFIG_FSI) += fsi/
|
obj-$(CONFIG_TEE) += tee/
|
obj-$(CONFIG_MULTIPLEXER) += mux/
|
obj-$(CONFIG_UNISYS_VISORBUS) += visorbus/
|
obj-$(CONFIG_SIOX) += siox/
|
obj-$(CONFIG_GNSS) += gnss/
|
obj-$(CONFIG_INTERCONNECT) += interconnect/
|
obj-$(CONFIG_COUNTER) += counter/
|
obj-$(CONFIG_MOST) += most/
|
obj-$(CONFIG_RK_FLASH) += rkflash/
|
obj-$(CONFIG_RK_HEADSET) += headset_observe/
|
obj-$(CONFIG_RK_NAND) += rk_nand/
|
obj-$(CONFIG_ROCKCHIP_RKNPU) += rknpu/
|
|
obj-$(CONFIG_XENOMAI) += xenomai/
|
