/* SPDX-License-Identifier: GPL-2.0 */
|
#ifndef _DVB_USB_M920X_H_
|
#define _DVB_USB_M920X_H_
|
|
#define DVB_USB_LOG_PREFIX "m920x"
|
#include "dvb-usb.h"
|
|
#define deb(args...) dprintk(dvb_usb_m920x_debug,0x01,args)
|
|
#define M9206_CORE 0x22
|
#define M9206_RC_STATE 0xff51
|
#define M9206_RC_KEY 0xff52
|
#define M9206_RC_INIT1 0xff54
|
#define M9206_RC_INIT2 0xff55
|
#define M9206_FW_GO 0xff69
|
|
#define M9206_I2C 0x23
|
#define M9206_FILTER 0x25
|
#define M9206_FW 0x30
|
|
#define M9206_MAX_FILTERS 8
|
#define M9206_MAX_ADAPTERS 4
|
|
/*
|
sequences found in logs:
|
[index value]
|
0x80 write addr
|
(0x00 out byte)*
|
0x40 out byte
|
|
0x80 write addr
|
(0x00 out byte)*
|
0x80 read addr
|
(0x21 in byte)*
|
0x60 in byte
|
|
this sequence works:
|
0x80 read addr
|
(0x21 in byte)*
|
0x60 in byte
|
|
Guess at API of the I2C function:
|
I2C operation is done one byte at a time with USB control messages. The
|
index the messages is sent to is made up of a set of flags that control
|
the I2C bus state:
|
0x80: Send START condition. After a START condition, one would normally
|
always send the 7-bit slave I2C address as the 7 MSB, followed by
|
the read/write bit as the LSB.
|
0x40: Send STOP condition. This should be set on the last byte of an
|
I2C transaction.
|
0x20: Read a byte from the slave. As opposed to writing a byte to the
|
slave. The slave will normally not produce any data unless you
|
set the R/W bit to 1 when sending the slave's address after the
|
START condition.
|
0x01: Respond with ACK, as opposed to a NACK. For a multi-byte read,
|
the master should send an ACK, that is pull SDA low during the 9th
|
clock cycle, after every byte but the last. This flags only makes
|
sense when bit 0x20 is set, indicating a read.
|
|
What any other bits might mean, or how to get the slave's ACK/NACK
|
response to a write, is unknown.
|
*/
|
|
struct m920x_state {
|
u16 filters[M9206_MAX_ADAPTERS][M9206_MAX_FILTERS];
|
int filtering_enabled[M9206_MAX_ADAPTERS];
|
int rep_count;
|
};
|
|
/* Initialisation data for the m920x
|
*/
|
|
struct m920x_inits {
|
u16 address;
|
u8 data;
|
};
|
|
#endif
|
