/*
|
* Configuation settings for the Hitachi Solution Engine 7722
|
*
|
* Copyright (C) 2007 Nobuhiro Iwamatsu <iwamatsu@nigauri.org>
|
*
|
* SPDX-License-Identifier: GPL-2.0+
|
*/
|
|
#ifndef __MS7722SE_H
|
#define __MS7722SE_H
|
|
#define CONFIG_CPU_SH7722 1
|
#define CONFIG_MS7722SE 1
|
|
#define CONFIG_DISPLAY_BOARDINFO
|
#undef CONFIG_SHOW_BOOT_PROGRESS
|
|
/* SMC9111 */
|
#define CONFIG_SMC91111
|
#define CONFIG_SMC91111_BASE (0xB8000000)
|
|
/* MEMORY */
|
#define MS7722SE_SDRAM_BASE (0x8C000000)
|
#define MS7722SE_FLASH_BASE_1 (0xA0000000)
|
#define MS7722SE_FLASH_BANK_SIZE (8*1024 * 1024)
|
|
#define CONFIG_SYS_TEXT_BASE 0x8FFC0000
|
#define CONFIG_SYS_LONGHELP /* undef to save memory */
|
#define CONFIG_SYS_PBSIZE 256 /* Buffer size for Console output */
|
#define CONFIG_SYS_BAUDRATE_TABLE { 115200 } /* List of legal baudrate settings for this board */
|
|
/* SCIF */
|
#define CONFIG_CONS_SCIF0 1
|
|
#define CONFIG_SYS_MEMTEST_START (MS7722SE_SDRAM_BASE)
|
#define CONFIG_SYS_MEMTEST_END (CONFIG_SYS_MEMTEST_START + (60 * 1024 * 1024))
|
|
#undef CONFIG_SYS_ALT_MEMTEST /* Enable alternate, more extensive, memory test */
|
#undef CONFIG_SYS_MEMTEST_SCRATCH /* Scratch address used by the alternate memory test */
|
|
#undef CONFIG_SYS_LOADS_BAUD_CHANGE /* Enable temporary baudrate change while serial download */
|
|
#define CONFIG_SYS_SDRAM_BASE (MS7722SE_SDRAM_BASE)
|
#define CONFIG_SYS_SDRAM_SIZE (64 * 1024 * 1024) /* maybe more, but if so u-boot doesn't know about it... */
|
|
#define CONFIG_SYS_LOAD_ADDR (CONFIG_SYS_SDRAM_BASE + 4 * 1024 * 1024) /* default load address for scripts ?!? */
|
|
#define CONFIG_SYS_MONITOR_BASE (MS7722SE_FLASH_BASE_1) /* Address of u-boot image
|
in Flash (NOT run time address in SDRAM) ?!? */
|
#define CONFIG_SYS_MONITOR_LEN (128 * 1024) /* */
|
#define CONFIG_SYS_MALLOC_LEN (256 * 1024) /* Size of DRAM reserved for malloc() use */
|
#define CONFIG_SYS_BOOTMAPSZ (8 * 1024 * 1024)
|
|
/* FLASH */
|
#define CONFIG_SYS_FLASH_CFI
|
#define CONFIG_FLASH_CFI_DRIVER
|
#undef CONFIG_SYS_FLASH_QUIET_TEST
|
#define CONFIG_SYS_FLASH_EMPTY_INFO /* print 'E' for empty sector on flinfo */
|
|
#define CONFIG_SYS_FLASH_BASE (MS7722SE_FLASH_BASE_1) /* Physical start address of Flash memory */
|
|
#define CONFIG_SYS_MAX_FLASH_SECT 150 /* Max number of sectors on each
|
Flash chip */
|
|
/* if you use all NOR Flash , you change dip-switch. Please see MS7722SE01 Manual. */
|
#define CONFIG_SYS_MAX_FLASH_BANKS 2
|
#define CONFIG_SYS_FLASH_BANKS_LIST { CONFIG_SYS_FLASH_BASE + (0 * MS7722SE_FLASH_BANK_SIZE), \
|
CONFIG_SYS_FLASH_BASE + (1 * MS7722SE_FLASH_BANK_SIZE), \
|
}
|
|
#define CONFIG_SYS_FLASH_ERASE_TOUT (3 * 1000) /* Timeout for Flash erase operations (in ms) */
|
#define CONFIG_SYS_FLASH_WRITE_TOUT (3 * 1000) /* Timeout for Flash write operations (in ms) */
|
#define CONFIG_SYS_FLASH_LOCK_TOUT (3 * 1000) /* Timeout for Flash set sector lock bit operations (in ms) */
|
#define CONFIG_SYS_FLASH_UNLOCK_TOUT (3 * 1000) /* Timeout for Flash clear lock bit operations (in ms) */
|
|
#undef CONFIG_SYS_FLASH_PROTECTION /* Use hardware flash sectors protection instead of U-Boot software protection */
|
|
#undef CONFIG_SYS_DIRECT_FLASH_TFTP
|
|
#define CONFIG_ENV_OVERWRITE 1
|
#define CONFIG_ENV_SECT_SIZE (8 * 1024)
|
#define CONFIG_ENV_SIZE (CONFIG_ENV_SECT_SIZE)
|
#define CONFIG_ENV_ADDR (CONFIG_SYS_FLASH_BASE + (1 * CONFIG_ENV_SECT_SIZE))
|
#define CONFIG_ENV_OFFSET (CONFIG_ENV_ADDR - CONFIG_SYS_FLASH_BASE) /* Offset of env Flash sector relative to CONFIG_SYS_FLASH_BASE */
|
#define CONFIG_ENV_SIZE_REDUND (CONFIG_ENV_SECT_SIZE)
|
#define CONFIG_ENV_ADDR_REDUND (CONFIG_SYS_FLASH_BASE + (2 * CONFIG_ENV_SECT_SIZE))
|
|
/* Board Clock */
|
#define CONFIG_SYS_CLK_FREQ 33333333
|
#define CONFIG_SH_TMU_CLK_FREQ CONFIG_SYS_CLK_FREQ
|
#define CONFIG_SH_SCIF_CLK_FREQ CONFIG_SYS_CLK_FREQ
|
#define CONFIG_SYS_TMU_CLK_DIV (4) /* 4 (default), 16, 64, 256 or 1024 */
|
|
#endif /* __MS7722SE_H */
|
