config IR_IMG
|
tristate "ImgTec IR Decoder"
|
depends on RC_CORE
|
depends on MIPS || COMPILE_TEST
|
select IR_IMG_HW if !IR_IMG_RAW
|
help
|
Say Y or M here if you want to use the ImgTec infrared decoder
|
functionality found in SoCs such as TZ1090.
|
|
config IR_IMG_RAW
|
bool "Raw decoder"
|
depends on IR_IMG
|
help
|
Say Y here to enable the raw mode driver which passes raw IR signal
|
changes to the IR raw decoders for software decoding. This is much
|
less reliable (due to lack of timestamps) and consumes more
|
processing power than using hardware decode, but can be useful for
|
testing, debug, and to make more protocols available.
|
|
config IR_IMG_HW
|
bool "Hardware decoder"
|
depends on IR_IMG
|
help
|
Say Y here to enable the hardware decode driver which decodes the IR
|
signals in hardware. This is more reliable, consumes less processing
|
power since only a single interrupt is received for each scancode,
|
and allows an IR scancode to be used as a wake event.
|
|
config IR_IMG_NEC
|
bool "NEC protocol support"
|
depends on IR_IMG_HW
|
help
|
Say Y here to enable support for the NEC, extended NEC, and 32-bit
|
NEC protocols in the ImgTec infrared decoder block.
|
|
config IR_IMG_JVC
|
bool "JVC protocol support"
|
depends on IR_IMG_HW
|
help
|
Say Y here to enable support for the JVC protocol in the ImgTec
|
infrared decoder block.
|
|
config IR_IMG_SONY
|
bool "Sony protocol support"
|
depends on IR_IMG_HW
|
help
|
Say Y here to enable support for the Sony protocol in the ImgTec
|
infrared decoder block.
|
|
config IR_IMG_SHARP
|
bool "Sharp protocol support"
|
depends on IR_IMG_HW
|
help
|
Say Y here to enable support for the Sharp protocol in the ImgTec
|
infrared decoder block.
|
|
config IR_IMG_SANYO
|
bool "Sanyo protocol support"
|
depends on IR_IMG_HW
|
help
|
Say Y here to enable support for the Sanyo protocol (used by Sanyo,
|
Aiwa, Chinon remotes) in the ImgTec infrared decoder block.
|
|
config IR_IMG_RC5
|
bool "Philips RC5 protocol support"
|
depends on IR_IMG_HW
|
help
|
Say Y here to enable support for the RC5 protocol in the ImgTec
|
infrared decoder block.
|
|
config IR_IMG_RC6
|
bool "Philips RC6 protocol support"
|
depends on IR_IMG_HW
|
help
|
Say Y here to enable support for the RC6 protocol in the ImgTec
|
infrared decoder block.
|
Note: This version only supports mode 0.
|
