LEDs connected to GPIO lines
|
|
Required properties:
|
- compatible : should be "gpio-leds".
|
|
Each LED is represented as a sub-node of the gpio-leds device. Each
|
node's name represents the name of the corresponding LED.
|
|
LED sub-node properties:
|
- gpios : Should specify the LED's GPIO, see "gpios property" in
|
Documentation/devicetree/bindings/gpio/gpio.txt. Active low LEDs should be
|
indicated using flags in the GPIO specifier.
|
- label : (optional)
|
see Documentation/devicetree/bindings/leds/common.txt
|
- linux,default-trigger : (optional)
|
see Documentation/devicetree/bindings/leds/common.txt
|
- default-state: (optional) The initial state of the LED.
|
see Documentation/devicetree/bindings/leds/common.txt
|
- retain-state-suspended: (optional) The suspend state can be retained.Such
|
as charge-led gpio.
|
- retain-state-shutdown: (optional) Retain the state of the LED on shutdown.
|
Useful in BMC systems, for example when the BMC is rebooted while the host
|
remains up.
|
- panic-indicator : (optional)
|
see Documentation/devicetree/bindings/leds/common.txt
|
|
Examples:
|
|
#include <dt-bindings/gpio/gpio.h>
|
|
leds {
|
compatible = "gpio-leds";
|
hdd {
|
label = "Disk Activity";
|
gpios = <&mcu_pio 0 GPIO_ACTIVE_LOW>;
|
linux,default-trigger = "disk-activity";
|
};
|
|
fault {
|
gpios = <&mcu_pio 1 GPIO_ACTIVE_HIGH>;
|
/* Keep LED on if BIOS detected hardware fault */
|
default-state = "keep";
|
};
|
};
|
|
run-control {
|
compatible = "gpio-leds";
|
red {
|
gpios = <&mpc8572 6 GPIO_ACTIVE_HIGH>;
|
default-state = "off";
|
};
|
green {
|
gpios = <&mpc8572 7 GPIO_ACTIVE_HIGH>;
|
default-state = "on";
|
};
|
};
|
|
leds {
|
compatible = "gpio-leds";
|
|
charger-led {
|
gpios = <&gpio1 2 GPIO_ACTIVE_HIGH>;
|
linux,default-trigger = "max8903-charger-charging";
|
retain-state-suspended;
|
};
|
};
|
