HiSilicon STB xHCI
|
|
The device node for HiSilicon STB xHCI host controller
|
|
Required properties:
|
- compatible: should be "hisilicon,hi3798cv200-xhci"
|
- reg: specifies physical base address and size of the registers
|
- interrupts : interrupt used by the controller
|
- clocks: a list of phandle + clock-specifier pairs, one for each
|
entry in clock-names
|
- clock-names: must contain
|
"bus": for bus clock
|
"utmi": for utmi clock
|
"pipe": for pipe clock
|
"suspend": for suspend clock
|
- resets: a list of phandle and reset specifier pairs as listed in
|
reset-names property.
|
- reset-names: must contain
|
"soft": for soft reset
|
- phys: a list of phandle + phy specifier pairs
|
- phy-names: must contain at least one of following:
|
"inno": for inno phy
|
"combo": for combo phy
|
|
Optional properties:
|
- usb2-lpm-disable: indicate if we don't want to enable USB2 HW LPM
|
- usb3-lpm-capable: determines if platform is USB3 LPM capable
|
- imod-interval-ns: default interrupt moderation interval is 40000ns
|
|
Example:
|
|
xhci0: xchi@f98a0000 {
|
compatible = "hisilicon,hi3798cv200-xhci";
|
reg = <0xf98a0000 0x10000>;
|
interrupts = <GIC_SPI 69 IRQ_TYPE_LEVEL_HIGH>;
|
clocks = <&crg HISTB_USB3_BUS_CLK>,
|
<&crg HISTB_USB3_UTMI_CLK>,
|
<&crg HISTB_USB3_PIPE_CLK>,
|
<&crg HISTB_USB3_SUSPEND_CLK>;
|
clock-names = "bus", "utmi", "pipe", "suspend";
|
resets = <&crg 0xb0 12>;
|
reset-names = "soft";
|
phys = <&usb2_phy1_port1 0>, <&combphy0 PHY_TYPE_USB3>;
|
phy-names = "inno", "combo";
|
};
|
