How to use U-Boot on Freescale MX6ULL 14x14 EVK
|
----------------------------------------------
|
|
- First make sure you have installed the dtc package (device tree compiler):
|
|
$ sudo apt-get install device-tree-compiler
|
|
- Build U-Boot for MX6ULL 14x14 EVK:
|
|
$ make mrproper
|
$ make mx6ull_14x14_evk_defconfig
|
$ make
|
|
This generates the u-boot-dtb.imx image in the current directory.
|
|
- Flash the u-boot-dtb.imx image into the micro SD card:
|
|
$ sudo dd if=u-boot-dtb.imx of=/dev/sdb bs=1K seek=1 && sync
|
|
- Jumper settings:
|
|
SW601: 0 0 1 0
|
Sw602: 1 0
|
|
Where 0 means bottom position and 1 means top position (from the switch label
|
numbers reference).
|
|
Connect the USB cable between the EVK and the PC for the console.
|
(The USB console connector is the one close the push buttons)
|
|
Insert the micro SD card in the board, power it up and U-Boot messages should
|
come up.
|
|
The link for the board: http://www.nxp.com/products/microcontrollers-and- \
|
processors/arm-processors/i.mx-applications-processors/i.mx-6-processors/ \
|
i.mx6qp/evaluation-kit-for-the-i.mx-6ull-applications-processor:MCIMX6ULL-EVK
|
