/*
|
* Copyright 2008 Freescale Semiconductor, Inc.
|
*
|
* SPDX-License-Identifier: GPL-2.0
|
*/
|
|
#include <common.h>
|
#include <i2c.h>
|
|
#include <fsl_ddr_sdram.h>
|
#include <fsl_ddr_dimm_params.h>
|
|
void get_spd(ddr2_spd_eeprom_t *spd, unsigned char i2c_address)
|
{
|
i2c_read(i2c_address, 0, 1, (uchar *)spd, sizeof(ddr2_spd_eeprom_t));
|
|
/* We use soldered memory, but use an SPD EEPROM to describe it.
|
* The SPD has an unspecified dimm type, but the DDR2 initialization
|
* code requires a specific type to be specified. This sets the type
|
* as a standard unregistered SO-DIMM. */
|
if (spd->dimm_type == 0) {
|
spd->dimm_type = 0x4;
|
((uchar *)spd)[63] += 0x4;
|
}
|
}
|
|
void fsl_ddr_board_options(memctl_options_t *popts,
|
dimm_params_t *pdimm,
|
unsigned int ctrl_num)
|
{
|
/*
|
* Factors to consider for clock adjust:
|
* - number of chips on bus
|
* - position of slot
|
* - DDR1 vs. DDR2?
|
* - ???
|
*
|
* This needs to be determined on a board-by-board basis.
|
* 0110 3/4 cycle late
|
* 0111 7/8 cycle late
|
*/
|
popts->clk_adjust = 7;
|
|
/*
|
* Factors to consider for CPO:
|
* - frequency
|
* - ddr1 vs. ddr2
|
*/
|
popts->cpo_override = 9;
|
|
/*
|
* Factors to consider for write data delay:
|
* - number of DIMMs
|
*
|
* 1 = 1/4 clock delay
|
* 2 = 1/2 clock delay
|
* 3 = 3/4 clock delay
|
* 4 = 1 clock delay
|
* 5 = 5/4 clock delay
|
* 6 = 3/2 clock delay
|
*/
|
popts->write_data_delay = 3;
|
|
/*
|
* Factors to consider for half-strength driver enable:
|
* - number of DIMMs installed
|
*/
|
popts->half_strength_driver_enable = 0;
|
}
|
