Overview
|
--------
|
QorIQ LS1012A FREEDOM (LS1012AFRDM) is a high-performance development
|
platform, with a complete debugging environment. The LS1012AFRDM board
|
supports the QorIQ LS1012A processor and is optimized to support the
|
high-bandwidth DDR3L memory and a full complement of high-speed SerDes ports.
|
|
LS1012A SoC Overview
|
--------------------
|
Please refer arch/arm/cpu/armv8/fsl-layerscape/doc/README.soc for LS2080A
|
SoC overview.
|
|
LS1012AFRDM board Overview
|
-----------------------
|
- SERDES Connections, 2 lanes supportingspeeds upto 1 Gbit/s
|
- 2 SGMII 1G PHYs
|
- DDR Controller
|
- 4 Gb DDR3L SDRAM memory, running at data rates up to 1 GT/s
|
operating at 1.35 V
|
- QSPI
|
- Onboard 512 Mbit QSPI flash memory running at speed up
|
to 108/54 MHz
|
- One high-speed USB 2.0/3.0 port, one USB 2.0 port
|
- USB 2.0/3.0 port is configured as On-The-Go (OTG) with a
|
Micro-AB connector.
|
- USB 2.0 port is a debug port (CMSIS DAP) and is configured
|
as a Micro-AB device.
|
- I2C controller
|
- One I2C bus with connectivity to Arduino headers
|
- UART
|
- UART (Console): UART1 (Without flow control) for console
|
- ARM JTAG support
|
- ARM Cortex® 10-pin JTAG connector for LS1012A
|
- CMSIS DAP through K20 microcontroller
|
- SAI Audio interface
|
- One SAI port, SAI 2 with full duplex support
|
- Clocks
|
- 25 MHz crystal for LS1012A
|
- 8 MHz Crystal for K20
|
- 24 MHz for SC16IS740IPW SPI to Dual UART bridge
|
- Power Supplies
|
- 5 V input supply from USB
|
- 0.9 V, 1.35 V, and 1.8 V for VDD/Core, DDR, I/O, and
|
other board interfaces
|
|
Booting Options
|
---------------
|
QSPI Flash 1
|
|
QSPI flash map
|
--------------
|
Images | Size |QSPI Flash Address
|
------------------------------------------
|
RCW + PBI | 1MB | 0x4000_0000
|
U-boot | 1MB | 0x4010_0000
|
U-boot Env | 1MB | 0x4020_0000
|
PPA FIT image | 2MB | 0x4050_0000
|
Linux ITB | ~53MB | 0x40A0_0000
|
