// SPDX-License-Identifier: GPL-2.0-only
|
/*
|
* OMAP 32ksynctimer/counter_32k-related code
|
*
|
* Copyright (C) 2009 Texas Instruments
|
* Copyright (C) 2010 Nokia Corporation
|
* Tony Lindgren <tony@atomide.com>
|
* Added OMAP4 support - Santosh Shilimkar <santosh.shilimkar@ti.com>
|
*
|
* NOTE: This timer is not the same timer as the old OMAP1 MPU timer.
|
*/
|
#include <linux/kernel.h>
|
#include <linux/init.h>
|
#include <linux/clk.h>
|
#include <linux/err.h>
|
#include <linux/io.h>
|
#include <linux/clocksource.h>
|
#include <linux/sched_clock.h>
|
|
#include <asm/mach/time.h>
|
|
#include <plat/counter-32k.h>
|
|
/* OMAP2_32KSYNCNT_CR_OFF: offset of 32ksync counter register */
|
#define OMAP2_32KSYNCNT_REV_OFF 0x0
|
#define OMAP2_32KSYNCNT_REV_SCHEME (0x3 << 30)
|
#define OMAP2_32KSYNCNT_CR_OFF_LOW 0x10
|
#define OMAP2_32KSYNCNT_CR_OFF_HIGH 0x30
|
|
/*
|
* 32KHz clocksource ... always available, on pretty most chips except
|
* OMAP 730 and 1510. Other timers could be used as clocksources, with
|
* higher resolution in free-running counter modes (e.g. 12 MHz xtal),
|
* but systems won't necessarily want to spend resources that way.
|
*/
|
static void __iomem *sync32k_cnt_reg;
|
|
static u64 notrace omap_32k_read_sched_clock(void)
|
{
|
return sync32k_cnt_reg ? readl_relaxed(sync32k_cnt_reg) : 0;
|
}
|
|
/**
|
* omap_read_persistent_clock64 - Return time from a persistent clock.
|
*
|
* Reads the time from a source which isn't disabled during PM, the
|
* 32k sync timer. Convert the cycles elapsed since last read into
|
* nsecs and adds to a monotonically increasing timespec64.
|
*/
|
static struct timespec64 persistent_ts;
|
static cycles_t cycles;
|
static unsigned int persistent_mult, persistent_shift;
|
|
static void omap_read_persistent_clock64(struct timespec64 *ts)
|
{
|
unsigned long long nsecs;
|
cycles_t last_cycles;
|
|
last_cycles = cycles;
|
cycles = sync32k_cnt_reg ? readl_relaxed(sync32k_cnt_reg) : 0;
|
|
nsecs = clocksource_cyc2ns(cycles - last_cycles,
|
persistent_mult, persistent_shift);
|
|
timespec64_add_ns(&persistent_ts, nsecs);
|
|
*ts = persistent_ts;
|
}
|
|
/**
|
* omap_init_clocksource_32k - setup and register counter 32k as a
|
* kernel clocksource
|
* @pbase: base addr of counter_32k module
|
* @size: size of counter_32k to map
|
*
|
* Returns 0 upon success or negative error code upon failure.
|
*
|
*/
|
int __init omap_init_clocksource_32k(void __iomem *vbase)
|
{
|
int ret;
|
|
/*
|
* 32k sync Counter IP register offsets vary between the
|
* highlander version and the legacy ones.
|
* The 'SCHEME' bits(30-31) of the revision register is used
|
* to identify the version.
|
*/
|
if (readl_relaxed(vbase + OMAP2_32KSYNCNT_REV_OFF) &
|
OMAP2_32KSYNCNT_REV_SCHEME)
|
sync32k_cnt_reg = vbase + OMAP2_32KSYNCNT_CR_OFF_HIGH;
|
else
|
sync32k_cnt_reg = vbase + OMAP2_32KSYNCNT_CR_OFF_LOW;
|
|
/*
|
* 120000 rough estimate from the calculations in
|
* __clocksource_update_freq_scale.
|
*/
|
clocks_calc_mult_shift(&persistent_mult, &persistent_shift,
|
32768, NSEC_PER_SEC, 120000);
|
|
ret = clocksource_mmio_init(sync32k_cnt_reg, "32k_counter", 32768,
|
250, 32, clocksource_mmio_readl_up);
|
if (ret) {
|
pr_err("32k_counter: can't register clocksource\n");
|
return ret;
|
}
|
|
sched_clock_register(omap_32k_read_sched_clock, 32, 32768);
|
register_persistent_clock(omap_read_persistent_clock64);
|
pr_info("OMAP clocksource: 32k_counter at 32768 Hz\n");
|
|
return 0;
|
}
|
