* STMicroelectronics SAS. ST21NFCA NFC Controller
|
|
Required properties:
|
- compatible: Should be "st,st21nfca-i2c".
|
- clock-frequency: I²C work frequency.
|
- reg: address on the bus
|
- enable-gpios: Output GPIO pin used for enabling/disabling the ST21NFCA
|
|
Optional SoC Specific Properties:
|
- pinctrl-names: Contains only one value - "default".
|
- pintctrl-0: Specifies the pin control groups used for this controller.
|
- ese-present: Specifies that an ese is physically connected to the nfc
|
controller.
|
- uicc-present: Specifies that the uicc swp signal can be physically
|
connected to the nfc controller.
|
|
Example (for ARM-based BeagleBoard xM with ST21NFCA on I2C2):
|
|
&i2c2 {
|
|
|
st21nfca: st21nfca@1 {
|
|
compatible = "st,st21nfca-i2c";
|
|
reg = <0x01>;
|
clock-frequency = <400000>;
|
|
interrupt-parent = <&gpio5>;
|
interrupts = <2 IRQ_TYPE_LEVEL_LOW>;
|
|
enable-gpios = <&gpio5 29 GPIO_ACTIVE_HIGH>;
|
|
ese-present;
|
uicc-present;
|
};
|
};
|
