Common MDIO bus properties.
|
|
These are generic properties that can apply to any MDIO bus.
|
|
Optional properties:
|
- reset-gpios: One GPIO that control the RESET lines of all PHYs on that MDIO
|
bus.
|
- reset-delay-us: RESET pulse width in microseconds.
|
|
A list of child nodes, one per device on the bus is expected. These
|
should follow the generic phy.txt, or a device specific binding document.
|
|
The 'reset-delay-us' indicates the RESET signal pulse width in microseconds and
|
applies to all PHY devices. It must therefore be appropriately determined based
|
on all PHY requirements (maximum value of all per-PHY RESET pulse widths).
|
|
Example :
|
This example shows these optional properties, plus other properties
|
required for the TI Davinci MDIO driver.
|
|
davinci_mdio: ethernet@5c030000 {
|
compatible = "ti,davinci_mdio";
|
reg = <0x5c030000 0x1000>;
|
#address-cells = <1>;
|
#size-cells = <0>;
|
|
reset-gpios = <&gpio2 5 GPIO_ACTIVE_LOW>;
|
reset-delay-us = <2>;
|
|
ethphy0: ethernet-phy@1 {
|
reg = <1>;
|
};
|
|
ethphy1: ethernet-phy@3 {
|
reg = <3>;
|
};
|
};
|
