ST USB EHCI controller
|
|
Required properties:
|
- compatible : must be "st,st-ehci-300x"
|
- reg : physical base addresses of the controller and length of memory mapped
|
region
|
- interrupts : one EHCI interrupt should be described here
|
- pinctrl-names : a pinctrl state named "default" must be defined
|
- pinctrl-0 : phandle referencing pin configuration of the USB controller
|
See: Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt
|
- clocks : phandle list of usb clocks
|
- clock-names : should be "ic" for interconnect clock and "clk48"
|
See: Documentation/devicetree/bindings/clock/clock-bindings.txt
|
|
- phys : phandle for the PHY device
|
- phy-names : should be "usb"
|
- resets : phandle + reset specifier pairs to the powerdown and softreset lines
|
of the USB IP
|
- reset-names : should be "power" and "softreset"
|
See: Documentation/devicetree/bindings/reset/st,sti-powerdown.txt
|
See: Documentation/devicetree/bindings/reset/reset.txt
|
|
Example:
|
|
ehci1: usb@fe203e00 {
|
compatible = "st,st-ehci-300x";
|
reg = <0xfe203e00 0x100>;
|
interrupts = <GIC_SPI 148 IRQ_TYPE_NONE>;
|
pinctrl-names = "default";
|
pinctrl-0 = <&pinctrl_usb1>;
|
clocks = <&clk_s_a1_ls 0>;
|
phys = <&usb2_phy>;
|
phy-names = "usb";
|
|
resets = <&powerdown STIH416_USB1_POWERDOWN>,
|
<&softreset STIH416_USB1_SOFTRESET>;
|
reset-names = "power", "softreset";
|
};
|
