* Faraday Technology FTGMAC100 gigabit ethernet controller
|
|
Required properties:
|
- compatible: "faraday,ftgmac100"
|
|
Must also contain one of these if used as part of an Aspeed AST2400
|
or 2500 family SoC as they have some subtle tweaks to the
|
implementation:
|
|
- "aspeed,ast2400-mac"
|
- "aspeed,ast2500-mac"
|
|
- reg: Address and length of the register set for the device
|
- interrupts: Should contain ethernet controller interrupt
|
|
Optional properties:
|
- phy-mode: See ethernet.txt file in the same directory. If the property is
|
absent, "rgmii" is assumed. Supported values are "rgmii*" and "rmii" for
|
aspeed parts. Other (unknown) parts will accept any value.
|
- use-ncsi: Use the NC-SI stack instead of an MDIO PHY. Currently assumes
|
rmii (100bT) but kept as a separate property in case NC-SI grows support
|
for a gigabit link.
|
- no-hw-checksum: Used to disable HW checksum support. Here for backward
|
compatibility as the driver now should have correct defaults based on
|
the SoC.
|
|
Example:
|
|
mac0: ethernet@1e660000 {
|
compatible = "aspeed,ast2500-mac", "faraday,ftgmac100";
|
reg = <0x1e660000 0x180>;
|
interrupts = <2>;
|
use-ncsi;
|
};
|
