PCI TEST
|
Kishon Vijay Abraham I <kishon@ti.com>
|
|
Traditionally PCI RC has always been validated by using standard
|
PCI cards like ethernet PCI cards or USB PCI cards or SATA PCI cards.
|
However with the addition of EP-core in linux kernel, it is possible
|
to configure a PCI controller that can operate in EP mode to work as
|
a test device.
|
|
The PCI endpoint test device is a virtual device (defined in software)
|
used to test the endpoint functionality and serve as a sample driver
|
for other PCI endpoint devices (to use the EP framework).
|
|
The PCI endpoint test device has the following registers:
|
|
1) PCI_ENDPOINT_TEST_MAGIC
|
2) PCI_ENDPOINT_TEST_COMMAND
|
3) PCI_ENDPOINT_TEST_STATUS
|
4) PCI_ENDPOINT_TEST_SRC_ADDR
|
5) PCI_ENDPOINT_TEST_DST_ADDR
|
6) PCI_ENDPOINT_TEST_SIZE
|
7) PCI_ENDPOINT_TEST_CHECKSUM
|
8) PCI_ENDPOINT_TEST_IRQ_TYPE
|
9) PCI_ENDPOINT_TEST_IRQ_NUMBER
|
|
*) PCI_ENDPOINT_TEST_MAGIC
|
|
This register will be used to test BAR0. A known pattern will be written
|
and read back from MAGIC register to verify BAR0.
|
|
*) PCI_ENDPOINT_TEST_COMMAND:
|
|
This register will be used by the host driver to indicate the function
|
that the endpoint device must perform.
|
|
Bitfield Description:
|
Bit 0 : raise legacy IRQ
|
Bit 1 : raise MSI IRQ
|
Bit 2 : raise MSI-X IRQ
|
Bit 3 : read command (read data from RC buffer)
|
Bit 4 : write command (write data to RC buffer)
|
Bit 5 : copy command (copy data from one RC buffer to another
|
RC buffer)
|
|
*) PCI_ENDPOINT_TEST_STATUS
|
|
This register reflects the status of the PCI endpoint device.
|
|
Bitfield Description:
|
Bit 0 : read success
|
Bit 1 : read fail
|
Bit 2 : write success
|
Bit 3 : write fail
|
Bit 4 : copy success
|
Bit 5 : copy fail
|
Bit 6 : IRQ raised
|
Bit 7 : source address is invalid
|
Bit 8 : destination address is invalid
|
|
*) PCI_ENDPOINT_TEST_SRC_ADDR
|
|
This register contains the source address (RC buffer address) for the
|
COPY/READ command.
|
|
*) PCI_ENDPOINT_TEST_DST_ADDR
|
|
This register contains the destination address (RC buffer address) for
|
the COPY/WRITE command.
|
|
*) PCI_ENDPOINT_TEST_IRQ_TYPE
|
|
This register contains the interrupt type (Legacy/MSI) triggered
|
for the READ/WRITE/COPY and raise IRQ (Legacy/MSI) commands.
|
|
Possible types:
|
- Legacy : 0
|
- MSI : 1
|
- MSI-X : 2
|
|
*) PCI_ENDPOINT_TEST_IRQ_NUMBER
|
|
This register contains the triggered ID interrupt.
|
|
Admissible values:
|
- Legacy : 0
|
- MSI : [1 .. 32]
|
- MSI-X : [1 .. 2048]
|
