| // SPDX-License-Identifier: GPL-2.0-only | 
| /dts-v1/; | 
|   | 
| #include "dm814x.dtsi" | 
| #include <dt-bindings/interrupt-controller/irq.h> | 
|   | 
| / { | 
|     model = "DM8148 EVM"; | 
|     compatible = "ti,dm8148-evm", "ti,dm8148", "ti,dm814"; | 
|   | 
|     memory@80000000 { | 
|         device_type = "memory"; | 
|         reg = <0x80000000 0x40000000>;    /* 1 GB */ | 
|     }; | 
|   | 
|     /* MIC94060YC6 controlled by SD1_POW pin */ | 
|     vmmcsd_fixed: fixedregulator0 { | 
|         compatible = "regulator-fixed"; | 
|         regulator-name = "vmmcsd_fixed"; | 
|         regulator-min-microvolt = <3300000>; | 
|         regulator-max-microvolt = <3300000>; | 
|     }; | 
| }; | 
|   | 
| &cpsw_emac0 { | 
|     phy-handle = <ðphy0>; | 
|     phy-mode = "rgmii-id"; | 
| }; | 
|   | 
| &cpsw_emac1 { | 
|     phy-handle = <ðphy1>; | 
|     phy-mode = "rgmii-id"; | 
| }; | 
|   | 
| &davinci_mdio { | 
|     ethphy0: ethernet-phy@0 { | 
|         reg = <0>; | 
|     }; | 
|   | 
|     ethphy1: ethernet-phy@1 { | 
|         reg = <1>; | 
|     }; | 
| }; | 
|   | 
| &gpmc { | 
|     ranges = <0 0 0x04000000 0x01000000>;    /* CS0: 16MB for NAND */ | 
|   | 
|     nand@0,0 { | 
|         compatible = "ti,omap2-nand"; | 
|         reg = <0 0 4>; /* CS0, offset 0, IO size 4 */ | 
|         interrupt-parent = <&gpmc>; | 
|         interrupts = <0 IRQ_TYPE_NONE>, /* fifoevent */ | 
|                  <1 IRQ_TYPE_NONE>; /* termcount */ | 
|         linux,mtd-name= "micron,mt29f2g16aadwp"; | 
|         #address-cells = <1>; | 
|         #size-cells = <1>; | 
|         ti,nand-ecc-opt = "bch8"; | 
|         nand-bus-width = <16>; | 
|         gpmc,device-width = <2>; | 
|         gpmc,sync-clk-ps = <0>; | 
|         gpmc,cs-on-ns = <0>; | 
|         gpmc,cs-rd-off-ns = <44>; | 
|         gpmc,cs-wr-off-ns = <44>; | 
|         gpmc,adv-on-ns = <6>; | 
|         gpmc,adv-rd-off-ns = <34>; | 
|         gpmc,adv-wr-off-ns = <44>; | 
|         gpmc,we-on-ns = <0>; | 
|         gpmc,we-off-ns = <40>; | 
|         gpmc,oe-on-ns = <0>; | 
|         gpmc,oe-off-ns = <54>; | 
|         gpmc,access-ns = <64>; | 
|         gpmc,rd-cycle-ns = <82>; | 
|         gpmc,wr-cycle-ns = <82>; | 
|         gpmc,bus-turnaround-ns = <0>; | 
|         gpmc,cycle2cycle-delay-ns = <0>; | 
|         gpmc,clk-activation-ns = <0>; | 
|         gpmc,wr-access-ns = <40>; | 
|         gpmc,wr-data-mux-bus-ns = <0>; | 
|         partition@0 { | 
|             label = "X-Loader"; | 
|             reg = <0 0x80000>; | 
|         }; | 
|         partition@0x80000 { | 
|             label = "U-Boot"; | 
|             reg = <0x80000 0x1c0000>; | 
|         }; | 
|         partition@0x1c0000 { | 
|             label = "Environment"; | 
|             reg = <0x240000 0x40000>; | 
|         }; | 
|         partition@0x280000 { | 
|             label = "Kernel"; | 
|             reg = <0x280000 0x500000>; | 
|         }; | 
|         partition@0x780000 { | 
|             label = "Filesystem"; | 
|             reg = <0x780000 0xf880000>; | 
|         }; | 
|     }; | 
| }; | 
|   | 
| &mmc1 { | 
|         status = "disabled"; | 
| }; | 
|   | 
| &mmc2 { | 
|     pinctrl-names = "default"; | 
|     pinctrl-0 = <&sd1_pins>; | 
|     vmmc-supply = <&vmmcsd_fixed>; | 
|     bus-width = <4>; | 
|     cd-gpios = <&gpio2 6 GPIO_ACTIVE_LOW>; | 
| }; | 
|   | 
| &mmc3 { | 
|         status = "disabled"; | 
| }; | 
|   | 
| &pincntl { | 
|     sd1_pins: pinmux_sd1_pins { | 
|         pinctrl-single,pins = < | 
|             DM814X_IOPAD(0x0800, PIN_INPUT | 0x1)    /* SD1_CLK */ | 
|             DM814X_IOPAD(0x0804, PIN_INPUT_PULLUP |  0x1)    /* SD1_CMD */ | 
|             DM814X_IOPAD(0x0808, PIN_INPUT_PULLUP |  0x1)    /* SD1_DAT[0] */ | 
|             DM814X_IOPAD(0x080c, PIN_INPUT_PULLUP |  0x1)    /* SD1_DAT[1] */ | 
|             DM814X_IOPAD(0x0810, PIN_INPUT_PULLUP |  0x1)    /* SD1_DAT[2] */ | 
|             DM814X_IOPAD(0x0814, PIN_INPUT_PULLUP |  0x1)    /* SD1_DAT[3] */ | 
|             DM814X_IOPAD(0x0924, PIN_OUTPUT |  0x40)    /* SD1_POW */ | 
|             DM814X_IOPAD(0x093C, PIN_INPUT_PULLUP |  0x80)    /* GP1[6] */ | 
|             >; | 
|     }; | 
|   | 
|     usb0_pins: pinmux_usb0_pins { | 
|         pinctrl-single,pins = < | 
|             DM814X_IOPAD(0x0c34, PIN_OUTPUT | 0x1)    /* USB0_DRVVBUS */ | 
|             >; | 
|     }; | 
|   | 
|     usb1_pins: pinmux_usb1_pins { | 
|         pinctrl-single,pins = < | 
|             DM814X_IOPAD(0x0834, PIN_OUTPUT | 0x80)    /* USB1_DRVVBUS */ | 
|             >; | 
|     }; | 
| }; | 
|   | 
| &usb0 { | 
|     pinctrl-names = "default"; | 
|     pinctrl-0 = <&usb0_pins>; | 
|     dr_mode = "host"; | 
| }; | 
|   | 
| &usb1 { | 
|     pinctrl-names = "default"; | 
|     pinctrl-0 = <&usb1_pins>; | 
|     dr_mode = "host"; | 
| }; |