* Toshiba TC358743 HDMI-RX to MIPI CSI2-TX Bridge
|
|
The Toshiba TC358743 HDMI-RX to MIPI CSI2-TX (H2C) is a bridge that converts
|
a HDMI stream to MIPI CSI-2 TX. It is programmable through I2C.
|
|
Required Properties:
|
|
- compatible: value should be "toshiba,tc358743"
|
- clocks, clock-names: should contain a phandle link to the reference clock
|
source, the clock input is named "refclk".
|
|
Optional Properties:
|
|
- reset-gpios: gpio phandle GPIO connected to the reset pin
|
- interrupts: GPIO connected to the interrupt pin
|
- data-lanes: should be <1 2 3 4> for four-lane operation,
|
or <1 2> for two-lane operation
|
- clock-lanes: should be <0>
|
- clock-noncontinuous: Presence of this boolean property decides whether the
|
MIPI CSI-2 clock is continuous or non-continuous.
|
- link-frequencies: List of allowed link frequencies in Hz. Each frequency is
|
expressed as a 64-bit big-endian integer. The frequency
|
is half of the bps per lane due to DDR transmission.
|
|
For further information on the MIPI CSI-2 endpoint node properties, see
|
Documentation/devicetree/bindings/media/video-interfaces.txt.
|
|
Example:
|
|
tc358743@f {
|
compatible = "toshiba,tc358743";
|
reg = <0x0f>;
|
clocks = <&hdmi_osc>;
|
clock-names = "refclk";
|
reset-gpios = <&gpio6 9 GPIO_ACTIVE_LOW>;
|
interrupt-parent = <&gpio2>;
|
interrupts = <5 IRQ_TYPE_LEVEL_HIGH>;
|
|
port {
|
tc358743_out: endpoint {
|
remote-endpoint = <&mipi_csi2_in>;
|
data-lanes = <1 2 3 4>;
|
clock-lanes = <0>;
|
clock-noncontinuous;
|
link-frequencies = /bits/ 64 <297000000>;
|
};
|
};
|
};
|
