| * OV2659 1/5-Inch 2Mp SOC Camera | 
|   | 
| The Omnivision OV2659 is a 1/5-inch SOC camera, with an active array size of | 
| 1632H x 1212V. It is programmable through a SCCB. The OV2659 sensor supports | 
| multiple resolutions output, such as UXGA, SVGA, 720p. It also can support | 
| YUV422, RGB565/555 or raw RGB output formats. | 
|   | 
| Required Properties: | 
| - compatible: Must be "ovti,ov2659" | 
| - reg: I2C slave address | 
| - clocks: reference to the xvclk input clock. | 
| - clock-names: should be "xvclk". | 
| - link-frequencies: target pixel clock frequency. | 
|   | 
| Optional Properties: | 
| - powerdown-gpios: reference to the GPIO connected to the pwdn pin, if any. | 
|   Active high with internal pull down resistor. | 
| - reset-gpios: reference to the GPIO connected to the resetb pin, if any. | 
|   Active low with internal pull up resistor. | 
|   | 
| For further reading on port node refer to | 
| Documentation/devicetree/bindings/media/video-interfaces.txt. | 
|   | 
| Example: | 
|   | 
|     i2c0@1c22000 { | 
|         ... | 
|         ... | 
|          ov2659@30 { | 
|             compatible = "ovti,ov2659"; | 
|             reg = <0x30>; | 
|   | 
|             clocks = <&clk_ov2659 0>; | 
|             clock-names = "xvclk"; | 
|   | 
|             powerdown-gpios = <&gpio6 14 GPIO_ACTIVE_HIGH>; | 
|             reset-gpios = <&gpio6 15 GPIO_ACTIVE_LOW>; | 
|   | 
|             port { | 
|                 ov2659_0: endpoint { | 
|                     remote-endpoint = <&vpfe_ep>; | 
|                     link-frequencies = /bits/ 64 <70000000>; | 
|                 }; | 
|             }; | 
|         }; | 
|         ... | 
|     }; |