* NXP Semiconductors PN532 NFC Controller
|
|
Required properties:
|
- compatible: Should be
|
- "nxp,pn532" Place a node with this inside the devicetree node of the bus
|
where the NFC chip is connected to.
|
Currently the kernel has phy bindings for uart and i2c.
|
- "nxp,pn532-i2c" (DEPRECATED) only works for the i2c binding.
|
- "nxp,pn533-i2c" (DEPRECATED) only works for the i2c binding.
|
|
Required properties if connected on i2c:
|
- clock-frequency: I²C work frequency.
|
- reg: for the I²C bus address. This is fixed at 0x24 for the PN532.
|
- interrupts: GPIO interrupt to which the chip is connected
|
|
Optional SoC Specific Properties:
|
- pinctrl-names: Contains only one value - "default".
|
- pintctrl-0: Specifies the pin control groups used for this controller.
|
|
Example (for ARM-based BeagleBone with PN532 on I2C2):
|
|
&i2c2 {
|
|
|
pn532: nfc@24 {
|
|
compatible = "nxp,pn532";
|
|
reg = <0x24>;
|
clock-frequency = <400000>;
|
|
interrupt-parent = <&gpio1>;
|
interrupts = <17 IRQ_TYPE_EDGE_FALLING>;
|
|
};
|
};
|
|
Example (for PN532 connected via uart):
|
|
uart4: serial@49042000 {
|
compatible = "ti,omap3-uart";
|
|
pn532: nfc {
|
compatible = "nxp,pn532";
|
};
|
};
|
