Qualcomm Ethernet ETHQOS device
|
|
This documents dwmmac based ethernet device which supports Gigabit
|
ethernet for version v2.3.0 onwards.
|
|
This device has following properties:
|
|
Required properties:
|
|
- compatible: Should be qcom,qcs404-ethqos"
|
|
- reg: Address and length of the register set for the device
|
|
- reg-names: Should contain register names "stmmaceth", "rgmii"
|
|
- clocks: Should contain phandle to clocks
|
|
- clock-names: Should contain clock names "stmmaceth", "pclk",
|
"ptp_ref", "rgmii"
|
|
- interrupts: Should contain phandle to interrupts
|
|
- interrupt-names: Should contain interrupt names "macirq", "eth_lpi"
|
|
Rest of the properties are defined in stmmac.txt file in same directory
|
|
|
Example:
|
|
ethernet: ethernet@7a80000 {
|
compatible = "qcom,qcs404-ethqos";
|
reg = <0x07a80000 0x10000>,
|
<0x07a96000 0x100>;
|
reg-names = "stmmaceth", "rgmii";
|
clock-names = "stmmaceth", "pclk", "ptp_ref", "rgmii";
|
clocks = <&gcc GCC_ETH_AXI_CLK>,
|
<&gcc GCC_ETH_SLAVE_AHB_CLK>,
|
<&gcc GCC_ETH_PTP_CLK>,
|
<&gcc GCC_ETH_RGMII_CLK>;
|
interrupts = <GIC_SPI 56 IRQ_TYPE_LEVEL_HIGH>,
|
<GIC_SPI 55 IRQ_TYPE_LEVEL_HIGH>;
|
interrupt-names = "macirq", "eth_lpi";
|
snps,reset-gpio = <&tlmm 60 GPIO_ACTIVE_LOW>;
|
snps,reset-active-low;
|
|
snps,txpbl = <8>;
|
snps,rxpbl = <2>;
|
snps,aal;
|
snps,tso;
|
|
phy-handle = <&phy1>;
|
phy-mode = "rgmii";
|
|
mdio {
|
#address-cells = <0x1>;
|
#size-cells = <0x0>;
|
compatible = "snps,dwmac-mdio";
|
phy1: phy@4 {
|
device_type = "ethernet-phy";
|
reg = <0x4>;
|
};
|
};
|
|
};
|
